Search:

Type: Posts; User: powerpickle

Page 1 of 10 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    6
    Views
    560

    That was because of your charger. Charging that...

    That was because of your charger. Charging that lipo battery at a 1C rate would be 5amps and from a 3.8 per cell storage voltage it would be charged in about an hour or less.
  2. Replies
    1
    Views
    567

    https://www.google.com/url?sa=t&rct=j&q=&esrc=s&so...

    https://www.google.com/url?sa=t&rct=j&q=&esrc=s&source=web&cd=2&cad=rja&uact=8&ved=0ahUKEwikudD26rLRAhUF0iYKHeVECLIQFggeMAE&url=https%3A%2F%2Ftraxxas.com%2Fsupport%2FWhat-Do-When-ESC-Flashing-Red-and-...
  3. Replies
    2
    Views
    786

    It sounds like the one way bearing is gummed up...

    It sounds like the one way bearing is gummed up and not engaging the starter shaft which works like a clutch and similar to an anti-revers bearing in a fishing reel.Remove and clean with alcohol and...
  4. If you are happy with what you have,that is great...

    If you are happy with what you have,that is great and all that matters.
    As far as that other thread,what he wrote and the link he posted,throw that rubbish in the trash.
  5. Replies
    3
    Views
    349

    You don't need to pair the controller/esc out of...

    You don't need to pair the controller/esc out of the box.
    What you did was select sport mode (1 blink red which is full forward/reverse and brake) 2 blinks is forward only with brake and 3 blinks is...
  6. I use the Titan 21t with a 21 tooth pinion,stock...

    I use the Titan 21t with a 21 tooth pinion,stock spur in my Telly. Top speed on 7 cell nimh and 2s is 18mph and 17 mph. Same as it was box stock except I have better torque,better slow speed control...
  7. Replies
    12
    Views
    1,640

    On those gears I used automotive wheel bearing...

    On those gears I used automotive wheel bearing grease.
  8. Replies
    12
    Views
    1,640

    I use 500k in both without any disadvantages to...

    I use 500k in both without any disadvantages to speak of such as decreased turning radius,it still turns very sharp as it did with the factory 100k fluid. The performance during climbing and crawling...
  9. Red and green blinking is the over voltage...

    Red and green blinking is the over voltage protection kicking in. Two 3s wired in series is the issue.
    You can use two 7 cell nimh or two 2s in series but not two 3s
  10. After selecting 4 amp and pressing the start...

    After selecting 4 amp and pressing the start button,the 1 amp led becomes 0-25% charge. The 2 amp led when lit displays 25-50% charged and so on with the other lights.
    The fast charge mode doesn't...
  11. Replies
    8
    Views
    532

    You can put electrical tape over the vent holes...

    You can put electrical tape over the vent holes to keep water out and air going in. Then you will only have centrifugal force. It's not perfect although it does help and easily redone when needed.
  12. Thread: wire size?

    by powerpickle
    Replies
    2
    Views
    301

    12 gauge wires

    12 gauge wires
  13. Replies
    4
    Views
    604

    The discharge rate for that charger is approx 1...

    The discharge rate for that charger is approx 1 amp. With the battery being full,the storage mode will take a LONG time. You're better off running the vehicle to discharge the battery then use the...
  14. Replies
    1
    Views
    480

    The car charger when flashing green is: 1 flash...

    The car charger when flashing green is: 1 flash equals 0-25% charged. 2 flashes 25-50% charged. 3 flashes 50-75% charged and 4 flashes is 75-100% charged. When fully charged all lights are off.
    I...
  15. Replies
    2
    Views
    975

    I will go to a car wash and rinse it but not...

    I will go to a car wash and rinse it but not power wash it up close,use a garden hose or even the shower in the bathroom. If I don't have an air compressor available to remove excess water I will use...
  16. Replies
    5
    Views
    223

    Thanks for sharing!

    Thanks for sharing!
  17. Replies
    22
    Views
    2,429

    He asked for other brushed options and "maybe"...

    He asked for other brushed options and "maybe" give a bit more speed. The 21t is a viable option and he could use the 23 tooth pinion.
  18. Replies
    22
    Views
    2,429

    Larger than stock but smaller than your attitude...

    Larger than stock but smaller than your attitude towards me
  19. Replies
    22
    Views
    2,429

    I made a typo,I meant to write "a larger pinion"

    I made a typo,I meant to write "a larger pinion"
  20. Check to see if the esc is in training mode,that...

    Check to see if the esc is in training mode,that mode will drop the voltage to the motor by approx 2v. The xl5 esc does this.I haven't tested the vxl yet however that mode will give a similar effect.
  21. Replies
    22
    Views
    2,429

    A high end brushed motor will be rebuildable and...

    A high end brushed motor will be rebuildable and better than a cheap quality brushless. Novak and Tekin and Axial come to mind. The Titan 21t with a smaller pinion is a good choice. Stay with a 550...
  22. Its true but I figured you would like that...

    Its true but I figured you would like that description lol
  23. The Telly is like a sister to the slash with the...

    The Telly is like a sister to the slash with the pede being a taller skinny cousin. Drop in a 21 to 35 turn,stock gears,500k plus diff fluid and a simple esc like an ae5 to have a drag brake and...
  24. Replies
    2
    Views
    672

    They are pre mounted 2.2/3.0

    They are pre mounted 2.2/3.0
  25. Replies
    2
    Views
    672

    Telluride bench testing

    A stock geared Telly with Pro-Line TSL SC Super Swampers and 500k diff fluid measured on 8.4v nimh
    12T motor bench test on 8.4v No load 5.3 amps. Stall load 19.7 amps
    ESC sport mode (8.4v),full...
Results 1 to 25 of 244
Page 1 of 10 1 2 3 4