Search:

Type: Posts; User: justin13703

Page 1 of 9 1 2 3 4

Search: Search took 6.69 seconds.

  1. Just take the wheel off and stick a 2 or 2.5mm...

    Just take the wheel off and stick a 2 or 2.5mm hex driver (I can’t remember which off the top of my head) into the top blue rubber seal on the outside of the axle carrier and loosen the screw inside...
  2. Replies
    5
    Views
    173

    Yeah if it is doing it only while sitting still,...

    Yeah if it is doing it only while sitting still, it’s definitely tsm related. They will even do that with the stock servos.
  3. Replies
    7
    Views
    221

    I have a set of the traxxas ones for my revo 2.0...

    I have a set of the traxxas ones for my revo 2.0 and they’re really nice. No matter what you do, they will sap a lot of power from the truck but they’re still a blast for crossing water and I wanted...
  4. Replies
    4
    Views
    270

    Yes that is what he’s saying because 2 6s...

    Yes that is what he’s saying because 2 6s batteries would be 12s.
  5. What’s up with the “New Posts” page?

    I like going to the new posts page and browsing to see what everyone’s talking about. Sometimes you’ll go there and there is 5+ pages of new posts shown, and other times there are 5 posts, and...
  6. Everyone has their own opinion but as far as...

    Everyone has their own opinion but as far as mine, if I was getting an 8 yr old into this stuff, I would absolutely use the traxxas batteries/chargers. The biggest negative is they are a bit more...
  7. I’m pretty sure that even the upgraded servo...

    I’m pretty sure that even the upgraded servo saver spring will not hold up to over 400 oz of torque. Meaning the spring will give before the servo maxes out it’s torque. So running two of them will...
  8. Replies
    9
    Views
    339

    Myself I just heated up the end of a metal coat...

    Myself I just heated up the end of a metal coat hanger until it was glowing and punched it right through. Leaves a nice hole (lol). I didn’t have any luck with the soldering iron method.
  9. Replies
    7
    Views
    375

    Ok sounds good. My worry is the added strain on...

    Ok sounds good. My worry is the added strain on the motor because it has slowed it down. I already had one stock motor die for no reason, don’t wanna give this one any reason at all lol. I’ll pull it...
  10. Replies
    9
    Views
    500

    Just run it you’ll be fine. I hose mine down with...

    Just run it you’ll be fine. I hose mine down with the garden hose literally every time I run it and I’ve taken mine across a lake with paddle tires. No issues. The holes in the tires is the only...
  11. Replies
    64
    Views
    2,710

    Man those augers are flying. I’m wondering if...

    Man those augers are flying. I’m wondering if they are spinning so fast that any snow will make it in and up the chute. Most snowblowers, the augers turn very slow. Either way it’s a sick setup and I...
  12. Replies
    7
    Views
    375

    Amount of grease on diff gears?

    How much grease is recommended to be put on the diff gears? I’m talking the ring and pinion gears, not the inside of the diff (which I know takes oil). A few days ago I pulled them apart and re...
  13. Ok cool I may try that, thanks for the help. I...

    Ok cool I may try that, thanks for the help. I already have bearings instead of the bushings. That seemed to make a big difference.
  14. Replies
    24
    Views
    937

    You can’t adjust the LVC on any of the traxxas...

    You can’t adjust the LVC on any of the traxxas esc’s, even with the Bluetooth module and app.
  15. Brushed to brushless gearing changes?

    I recently converted my brushed 2wd stampede to the traxxas velineon system. I run it on a 2s 5800mah battery. I’ve noticed that it seems to handle the power very well, and the new brushless motor...
  16. Replies
    24
    Views
    937

    Yeah I see what you were saying. I’m sure full...

    Yeah I see what you were saying. I’m sure full voltage isn’t applied to that button. I agree that most of the time control circuits use a lower voltage or a ground signal.
  17. Replies
    24
    Views
    937

    If I remember correctly anti spark connectors...

    If I remember correctly anti spark connectors have a small resistor built into the plug. As you plug the connectors together, it first contacts the resistor circuit which only lets a small amount of...
  18. Ok cool. That makes me feel better. Never had a...

    Ok cool. That makes me feel better. Never had a set before so I didn’t really know what to expect.

    I’d like to try them out in the snow too, but apparently the weather in MD has no desire to bring...
  19. Replies
    24
    Views
    937

    Yeah that’s the one.

    Yeah that’s the one.
  20. Replies
    24
    Views
    937

    Could be a few things, I’d start a thread for it...

    Could be a few things, I’d start a thread for it and provide some more details about the truck and the batteries you are using.
  21. Replies
    24
    Views
    937

    Any time the batteries are plugged in the esc...

    Any time the batteries are plugged in the esc will have battery voltage. I was saying unplugging stuff while they’re turned on has always been a bad thing in my eyes. As long as the current draw is...
  22. That is completely normal and the servo saver is...

    That is completely normal and the servo saver is doing its job. There is nothing wrong with the truck. It is taking the strain of trying to turn the wheels on carpet (or anything else that holds the...
  23. Replies
    14
    Views
    1,110

    Set the multi function knob to be throttle trim...

    Set the multi function knob to be throttle trim instead of tsm adjustment
  24. Water crossing and paddle tires questions

    So I got a set of paddle tires for Christmas and decided to try to cross a pond near a friend’s house with it. I have never tried this before so I was really nervous to just drive an rc car of this...
  25. Replies
    24
    Views
    937

    Well it said right on the update notes that they...

    Well it said right on the update notes that they were removing the ability to turn off the esc with the button in that update. So that is by design. I don’t like this either, but I guess there was a...
Results 1 to 25 of 210
Page 1 of 9 1 2 3 4