Search:

Type: Posts; User: Double G

Page 1 of 20 1 2 3 4

Search: Search took 0.50 seconds; generated 46 minute(s) ago.

  1. It could be based upon the cookies in your...

    It could be based upon the cookies in your browser. I have found that I can read threads and then go back to the main page and it still shows new posts in that subforum - posts that I have read. If...
  2. Try leaning the LSN a little bit and restart. I...

    Try leaning the LSN a little bit and restart. I don't know why the shop said to let it idle since it was sitting too long - just start it and drive it around easily so that the oil in the fuel can...
  3. Replies
    5
    Views
    115

    And that's why two are getting closed.

    And that's why two are getting closed.
  4. Replies
    4
    Views
    119

    Tighten until the screws touch the plastic and...

    Tighten until the screws touch the plastic and then a little more for good measure. Any tighter and the plastic diff housings or bulkheads will deform.
  5. Replies
    4
    Views
    106

    Take this set-up (but halfsies) and that is what...

    Take this set-up (but halfsies) and that is what I run.




    IMHO, 5700kv is too high for this truck. You'll be better at 3800kv and much happier around 2400kv.

    Here is what Castle even says...
  6. Replies
    2
    Views
    107

    nimh batteries do not need the balance wires. If...

    nimh batteries do not need the balance wires. If you can find the female legacy High-Current connectors go with those. Otherwise you'll have to do some digging to find current iD connector for the...
  7. Thread: Bearing oil

    by Double G
    Replies
    13
    Views
    343

    They're not. You were answering in another...

    They're not. You were answering in another thread eleven hours ago: https://forums.traxxas.com/showthread.php?9090839-Ring-and-Pinion&p=6521640#post6521640

    :lol:
  8. Replies
    12
    Views
    256

    The carb will close only as far as the idle screw...

    The carb will close only as far as the idle screw will allow - no further. The linkage and collar are not to be set up to set the idle.
  9. Thread: Please help!!

    by Double G
    Replies
    12
    Views
    282

    Probably with the paper strip method as mentioned...

    Probably with the paper strip method as mentioned in the manual(s).
  10. Replies
    12
    Views
    256

    In addition, the collar on the linkage should...

    In addition, the collar on the linkage should have a very small gap between it and the horn at idle. You may not have it adjusted correctly and when you apply the brake the two separate and the carb...
  11. If you have the brushed version then you cannot...

    If you have the brushed version then you cannot use it. There are 3s batteries that will fit but the ESC will go into over-voltage protection as it has a limit of 2s.
  12. Thread: slash shocks

    by Double G
    Replies
    3
    Views
    139

    The Revo/Summit/Slayer shock bodies are all the...

    The Revo/Summit/Slayer shock bodies are all the same size - front and back. The Slash GTRs are taller - especially the XX-long in the rear. The problem with replacing just the shafts is that they...
  13. Replies
    6
    Views
    154

    With the engine off do a test (simulate the...

    With the engine off do a test (simulate the length of time of your WOT pass) with the electronics and see what happens to the servo - does it open halfway or full the second time around? What...
  14. Thread: Please help!!

    by Double G
    Replies
    12
    Views
    282

    Test the motor out of the truck. If all is well...

    Test the motor out of the truck. If all is well then with it still out spin everything that is supposed to spin by harms and feel for resistance.

    If the motor still acts up try with another...
  15. Thread: 2S batteries

    by Double G
    Replies
    22
    Views
    349

    What is the pack voltage at the main terminal?

    What is the pack voltage at the main terminal?
  16. Replies
    12
    Views
    256

    The carb should not fully close at idle unless...

    The carb should not fully close at idle unless you want to restart the engine every time you stop. 0.7-1.0 mm open at idle.


    And watch the acronyms as well. Per Traxxas: no no.
  17. Replies
    6
    Views
    141

    It's not advertised but LVC is around 3.2-3.3v /...

    It's not advertised but LVC is around 3.2-3.3v / cell. Many battery manufacturers (such as the late SPC) recommended 3.5v.
  18. nimh do not suffer the same memory effect that...

    nimh do not suffer the same memory effect that nicd batteries do so you can charge them at any point. I keep them fully charged for storage and after a few runs I top them off. I have a pair of...
  19. Thread: TSM Question

    by Double G
    Replies
    8
    Views
    210

    Tsm ?

    Tsm ?
  20. Replies
    3
    Views
    99

    Page 28 of your manual?

    Page 28 of your manual?
  21. Replies
    3
    Views
    111

    6 cell nimh pack - they are all the same size. ...

    6 cell nimh pack - they are all the same size. If I recall the battery for the wand needs to have a Tamiya connector.
  22. Replies
    10
    Views
    262

    A good tune will take care of that. With any...

    A good tune will take care of that. With any starter - whether on an auto, small engine or RC - you don’t crank for more than 10-15 seconds otherwise the starter overheats.
  23. Replies
    6
    Views
    171

    You can put whatever price you want on them, but...

    You can put whatever price you want on them, but $600 and $700 will leave them sitting in your possession for a long time. Don't expect someone to pay more for something when they can go to the...
  24. Thread: Is this okay?

    by Double G
    Replies
    6
    Views
    198

    The only problem is you got a battery the ESC is...

    The only problem is you got a battery the ESC is not designed to handle. Once you are used to the brushed system or one of the component fails, get a brushless system.
  25. Thread: Is this okay?

    by Double G
    Replies
    6
    Views
    198

    Is the Rustler the XL-5 or the VXL? If the...

    Is the Rustler the XL-5 or the VXL? If the brushed system the max it can take is 2s.
Results 1 to 25 of 494
Page 1 of 20 1 2 3 4