Search:

Type: Posts; User: the-one1

Page 1 of 2 1 2

Search: Search took 0.03 seconds.

  1. Replies
    8
    Views
    2,119

    Rechargeables have more OOOMPH than alkalines.

    Rechargeables have more OOOMPH than alkalines.
  2. Replies
    6
    Views
    2,103

    I saw yours. I thought about it, and I might do...

    I saw yours. I thought about it, and I might do that once I get a chance to run this thing this summer.
  3. Replies
    6
    Views
    2,103

    Right now without the throttle/brake servo, it...

    Right now without the throttle/brake servo, it does feel heavier on the "drivers" side since the battery and servo are on that side with the engine offside centered to that same side. I'll see how it...
  4. Replies
    6
    Views
    2,103

    I used CA glue for the belt. I hope it will hold....

    I used CA glue for the belt. I hope it will hold. And as for the exposed servo, my HPI R40 and RS4 3 Drift has their servos sticking out just like this. ...
  5. Replies
    6
    Views
    2,103

    Pulley/chasis mod

    I figure I'd post this here just to see what everyone thought about this mod.
    Can you see my mods?:D
    http://i292.photobucket.com/albums/mm23/the-one1/P1040008.jpg...
  6. Replies
    151
    Views
    199,591

    Sticky: Here's mine so far. Can you see my mods?:D ...

    Here's mine so far. Can you see my mods?:D
    http://i292.photobucket.com/albums/mm23/the-one1/P1040008.jpg
    http://i292.photobucket.com/albums/mm23/the-one1/P1040007.jpg...
  7. Replies
    7
    Views
    940

    What I did was remove the tie rod ends and...

    What I did was remove the tie rod ends and replaced them with ball cups. Loose and smooth yet no wiggle.:wub: I just replaced the tie rod from the servo to the crank and the ackerman (center) tie...
  8. Replies
    2
    Views
    1,172

    Towards the carb, the oil enter through the crank...

    Towards the carb, the oil enter through the crank shaft and falls into the hole.
  9. Replies
    10
    Views
    1,102

    The biggest wheels that you can put in it are Hpi...

    The biggest wheels that you can put in it are Hpi super nitro wheels. Lager than 1/10 touring and smaller than 1/8. Kinda liek a 1/9 size.
  10. Replies
    10
    Views
    1,173

    One thing to consider, curbs move faster than r/c...

    One thing to consider, curbs move faster than r/c cars even if they look stationary.
  11. Replies
    2
    Views
    1,005

    cool :)

    cool :)
  12. Replies
    2
    Views
    1,005

    Conrod direction?

    Which way does the conrod in the 2.5 face, the little oil hole towards the crank hole or towards the rear.

    Also, which way does the piston face, the big cut out on the bottom towards the crank or...
  13. Replies
    6
    Views
    993

    It has less than 1 gallon in it. The sleeve is...

    It has less than 1 gallon in it. The sleeve is fine, and so it the crank and piston surface and sides. All I need is a new conrod.
  14. Replies
    6
    Views
    993

    The p/s were in good shape, except for a small...

    The p/s were in good shape, except for a small nick on the bottome of the piston where it doesnt touch the sleeve. The back of the crank has slight rust. The transfer channels ahve gunk too, but not...
  15. Replies
    6
    Views
    993

    Bad conrod, bad boy

    Man:( I was getting ready to drift my n4-tec, and I didnt even think to warm it up a little (which I usaully do), and I gunned it and made at least 3 drifting turns when it seized up. Couldnt pull...
  16. Replies
    3
    Views
    975

    I switched over to the pull start. Its sooooo...

    I switched over to the pull start. Its sooooo much lighter than the ez start. If you take out the ez start, you'll feel how much it weighs.
  17. Rock stuck in the gears

    Rock stuck in the gears
  18. Like terry said, adding the 2spd will not make it...

    Like terry said, adding the 2spd will not make it faster. For one thing, the stock .15fe engine sucks gass big time. ABN contrustion and like .5 or less hp. Its fast if thats the 1st nitro you have...
  19. Replies
    3
    Views
    837

    Pop ups asking to install stuff. hmmmm banned?

    Pop ups asking to install stuff. hmmmm banned?
  20. Thread: glow plug

    by the-one1
    Replies
    3
    Views
    865

    1/10 AND 1/8 (.12-.23+) size engines use similiar...

    1/10 AND 1/8 (.12-.23+) size engines use similiar size plugs (except turbo plugs). Its just the temperature of the plugs differ with size.
  21. Replies
    13
    Views
    2,325

    What do you guys prefer? Apples or Peaches. I...

    What do you guys prefer? Apples or Peaches. I like Peaches myself.
    Anyways, the final decision comes down to: what does your lhs carry most in parts?
    If they dont carry anyparts for the car you...
  22. Replies
    13
    Views
    2,325

    I have both cars. the rs4 rtr upgraded to the new...

    I have both cars. the rs4 rtr upgraded to the new evo t-15 engine.
    The fuel tank isnt held on by body clips, its held down by screws.
    The 4-tec is way faster hands down. but the rs4 does handle...
  23. Replies
    13
    Views
    1,273

    My post was to the original poster carguy70001....

    My post was to the original poster carguy70001. Wider belt could be ur answer, with new teeths.
  24. Replies
    13
    Views
    1,273

    Did you have the original .15 or the "newer" 2.5....

    Did you have the original .15 or the "newer" 2.5. Cause the 2.5 has a wider rear belt than the .15. The .15 and the electric 4tec has the same rear belt, skinny.
  25. Replies
    4
    Views
    1,068

    Do you work for Wendy's, uh, I mean for Fantom or...

    Do you work for Wendy's, uh, I mean for Fantom or do you unofficially.
    Thye are nice engines btw.
Results 1 to 25 of 45
Page 1 of 2 1 2