Search:

Type: Posts; User: Trojan366

Page 1 of 6 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    47
    Views
    1,301

    I don’t want to post a for sale ad but I’ve been...

    I don’t want to post a for sale ad but I’ve been insanely busy and don’t have much time to bring this thing out and run it. Would anyone be interested in buying it? I could sell it complete as is or...
  2. Replies
    6
    Views
    504

    Are you landing wide open throttle?

    Are you landing wide open throttle?
  3. Are the Tetons able to drive on the lawn without...

    Are the Tetons able to drive on the lawn without overheating? I’d assume even though they are smaller scale the design might give them a leg up there.
  4. 1/16 Slash 4x4 or Latrax Teton for 4 year old

    My daughter is turning four and would like a remote control like mine. Curious if anyone has any input between the 1/16 slash, teton and prerunner. I want something that will grow with her. I'd...
  5. Replies
    4
    Views
    121

    is the gear mesh set properly? If things are too...

    is the gear mesh set properly? If things are too tight it will cause binding.
  6. Replies
    18
    Views
    272

    It already seems like a better radio. I am...

    It already seems like a better radio. I am considering swapping my slash 4x4 over to a spektrum receiver as well!
  7. Replies
    47
    Views
    1,301

    Finally got my steering issue sorted with a new...

    Finally got my steering issue sorted with a new radio and receiver. I also jumped to a 31t pinion. Drove around work for a few minutes and the motor has plenty of power but it seems to be getting...
  8. Replies
    18
    Views
    272

    Spent 5 minutes last night installing and binding...

    Spent 5 minutes last night installing and binding the new radio and receiver. I still need to set endpoint and adjust things a bit but the steering goes both ways now. Something in the stock radio...
  9. Replies
    9
    Views
    638

    You can get a brand new set of all 4 shocks and...

    You can get a brand new set of all 4 shocks and springs filled with oil on eBay for less than $20 shipped. Might be worth it to have some spares around.
  10. Looks mint. Run it.

    Looks mint. Run it.
  11. Replies
    18
    Views
    272

    Ordered a dx5c and receiver. Probably not a bad...

    Ordered a dx5c and receiver. Probably not a bad idea for range purposes but should help solve or at least narrow down my issue.
  12. Replies
    28
    Views
    921

    Springs made a huge difference! The front end is...

    Springs made a huge difference! The front end is much more planted and will actually steers under part throttle. I have a bit more adjusting to do but if anyone is looking to run GTR shocks on the...
  13. Replies
    18
    Views
    272

    I have been leaning towards a Tx/Rx issue because...

    I have been leaning towards a Tx/Rx issue because both servos turns much further in one direction than the other. With nothing attached both the new and old servos did the same thing.
  14. Replies
    18
    Views
    272

    I’m not sure if the drag link is too long or...

    I’m not sure if the drag link is too long or short since I’m not sure how long it should be haha. I was wondering about the tsm. It is a Traxxas tqi transmitter and the appropriate receiver but as...
  15. Replies
    18
    Views
    272

    I have tried the servo horn at 11, 12 and 1...

    I have tried the servo horn at 11, 12 and 1 o’clock positions. Everything in the front end seems to be properly assembled and turns freely when the drag link is removed.
  16. Replies
    18
    Views
    272

    I measured both tie rods and they are within a...

    I measured both tie rods and they are within a couple of mm.
  17. Replies
    18
    Views
    272

    Tried that twice and nothing. I’m stumped.

    Tried that twice and nothing. I’m stumped.
  18. Replies
    18
    Views
    272

    Barely steers left?

    I have done a bunch of reading and can’t figure this one out. My rustler steers too far right and barely turns left. I reset the transmitter. I reset steering endpoints. I replaced the Servo. There...
  19. Replies
    12
    Views
    455

    I know nothing about that motor and esc but if...

    I know nothing about that motor and esc but if they can handle 2s or 3s lipid they would completely change how it drives.
  20. Replies
    12
    Views
    455

    Are you happy with how it runs now? Yes- don’t...

    Are you happy with how it runs now?
    Yes- don’t upgrade
    No- consider upgrading
  21. Thread: Screw Set

    by Trojan366
    Replies
    14
    Views
    311

    I ordered a set of vxl take off screws from eBay...

    I ordered a set of vxl take off screws from eBay and it was pretty complete. I havenít found anything it was missing yet.
  22. Replies
    47
    Views
    1,301

    Almost looks too good. I’m not sure I want to...

    Almost looks too good. I’m not sure I want to risk flipping it over lol. I’ll probably run it tomorrow and see how it feels. This body is a bit wider behind the front wheels than stock. I am hoping...
  23. Replies
    47
    Views
    1,301

    Body is done. Not bad for maybe an hour. I was...

    Body is done. Not bad for maybe an hour. I was planning on masking the “bed” and back window areas but got distracted and forgot. Still pretty happy with how it turned out!...
  24. Replies
    10
    Views
    162

    Higher gearing puts more stress and load on the...

    Higher gearing puts more stress and load on the motor, esc and battery.
  25. Replies
    10
    Views
    162

    yes 32p. I am debating whether to jump to a 31...

    yes 32p. I am debating whether to jump to a 31 or 34t pinion or just got right to mod 1 gearing. Also not sure when the gearing will overload my electronics. I am assuming my 5000mah 3s traxxas...
Results 1 to 25 of 139
Page 1 of 6 1 2 3 4