Search:

Type: Posts; User: Double G

Page 1 of 20 1 2 3 4

Search: Search took 0.45 seconds.

  1. Thread: Bearing oil

    by Double G
    Replies
    11
    Views
    243

    They're not. You were answering in another...

    They're not. You were answering in another thread eleven hours ago: https://forums.traxxas.com/showthread.php?9090839-Ring-and-Pinion&p=6521640#post6521640

    :lol:
  2. Replies
    10
    Views
    122

    The carb will close only as far as the idle screw...

    The carb will close only as far as the idle screw will allow - no further. The linkage and collar are not to be set up to set the idle.
  3. Thread: Please help!!

    by Double G
    Replies
    11
    Views
    189

    Probably with the paper strip method as mentioned...

    Probably with the paper strip method as mentioned in the manual(s).
  4. Replies
    10
    Views
    122

    In addition, the collar on the linkage should...

    In addition, the collar on the linkage should have a very small gap between it and the horn at idle. You may not have it adjusted correctly and when you apply the brake the two separate and the carb...
  5. If you have the brushed version then you cannot...

    If you have the brushed version then you cannot use it. There are 3s batteries that will fit but the ESC will go into over-voltage protection as it has a limit of 2s.
  6. Thread: slash shocks

    by Double G
    Replies
    3
    Views
    108

    The Revo/Summit/Slayer shock bodies are all the...

    The Revo/Summit/Slayer shock bodies are all the same size - front and back. The Slash GTRs are taller - especially the XX-long in the rear. The problem with replacing just the shafts is that they...
  7. Replies
    6
    Views
    111

    With the engine off do a test (simulate the...

    With the engine off do a test (simulate the length of time of your WOT pass) with the electronics and see what happens to the servo - does it open halfway or full the second time around? What...
  8. Thread: Please help!!

    by Double G
    Replies
    11
    Views
    189

    Test the motor out of the truck. If all is well...

    Test the motor out of the truck. If all is well then with it still out spin everything that is supposed to spin by harms and feel for resistance.

    If the motor still acts up try with another...
  9. Thread: 2S batteries

    by Double G
    Replies
    22
    Views
    289

    What is the pack voltage at the main terminal?

    What is the pack voltage at the main terminal?
  10. Replies
    10
    Views
    122

    The carb should not fully close at idle unless...

    The carb should not fully close at idle unless you want to restart the engine every time you stop. 0.7-1.0 mm open at idle.


    And watch the acronyms as well. Per Traxxas: no no.
  11. Replies
    6
    Views
    107

    It's not advertised but LVC is around 3.2-3.3v /...

    It's not advertised but LVC is around 3.2-3.3v / cell. Many battery manufacturers (such as the late SPC) recommended 3.5v.
  12. nimh do not suffer the same memory effect that...

    nimh do not suffer the same memory effect that nicd batteries do so you can charge them at any point. I keep them fully charged for storage and after a few runs I top them off. I have a pair of...
  13. Thread: TSM Question

    by Double G
    Replies
    8
    Views
    175

    Tsm ?

    Tsm ?
  14. Replies
    3
    Views
    74

    Page 28 of your manual?

    Page 28 of your manual?
  15. Replies
    3
    Views
    101

    6 cell nimh pack - they are all the same size. ...

    6 cell nimh pack - they are all the same size. If I recall the battery for the wand needs to have a Tamiya connector.
  16. Replies
    10
    Views
    154

    A good tune will take care of that. With any...

    A good tune will take care of that. With any starter - whether on an auto, small engine or RC - you don’t crank for more than 10-15 seconds otherwise the starter overheats.
  17. Replies
    6
    Views
    133

    You can put whatever price you want on them, but...

    You can put whatever price you want on them, but $600 and $700 will leave them sitting in your possession for a long time. Don't expect someone to pay more for something when they can go to the...
  18. Thread: Is this okay?

    by Double G
    Replies
    6
    Views
    172

    The only problem is you got a battery the ESC is...

    The only problem is you got a battery the ESC is not designed to handle. Once you are used to the brushed system or one of the component fails, get a brushless system.
  19. Thread: Is this okay?

    by Double G
    Replies
    6
    Views
    172

    Is the Rustler the XL-5 or the VXL? If the...

    Is the Rustler the XL-5 or the VXL? If the brushed system the max it can take is 2s.
  20. Replies
    1
    Views
    81

    Have you replaced anything? Is it new? Bought...

    Have you replaced anything? Is it new? Bought it used? Check the pillow ball retainers on the axle carriers to see if they are too tight. You want them to be tight enough to reduce slop but not...
  21. https://forums.traxxas.com/showthread.php?199623-C...

    https://forums.traxxas.com/showthread.php?199623-Community-goals
  22. Replies
    6
    Views
    59

    You may have to trim the tab off the side of the...

    You may have to trim the tab off the side of the plug.
  23. 1: You can take the link off the servo and...

    1: You can take the link off the servo and adjust it as necessary - if you want.

    2: Best way to get water out is small holes in the middle of the tires. Or don't drive through puddles.

    3:...
  24. Replies
    17
    Views
    343

    Do you have Opti-Drive installed?

    Do you have Opti-Drive installed?
  25. Replies
    7
    Views
    158

    Maybe broke the magnets inside the motor.

    Maybe broke the magnets inside the motor.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4