Search:

Type: Posts; User: Gman313

Page 1 of 6 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    13
    Views
    2,901

    Looking good and that is a decent speed! I've...

    Looking good and that is a decent speed!

    I've never run this boat in snow but I ran a proboat cat in snow once. Was fun just watch your temps as the load will be much different depending how wet...
  2. Replies
    13
    Views
    2,901

    Looks good let me know how it goes. I'm in Canada...

    Looks good let me know how it goes. I'm in Canada under a foot of snow no boating for me anytime soon.

    Correct on the wires but give the throttle a test blip, if the motor spins backwards switch...
  3. Replies
    1
    Views
    1,114

    M41 Full Telemetry Install

    So I had the expansion pack and GPS. Now that Traxxas was kind enough to put out a marine telemetry install video I've purchased all the sensors and am going for full telemetry including temp on both...
  4. Replies
    13
    Views
    2,901

    There is someone on the Traxxas m41 owners...

    There is someone on the Traxxas m41 owners facebook group that did it.

    Locally a guy did it with his Spartan and the thing hauls!
  5. Replies
    2
    Views
    286

    Thank-you!

    Thank-you!
  6. Replies
    2
    Views
    286

    1/8 Electronics and Telemetry

    Hey all,

    Just love my slash (and my m41 but that is another forum). Have the regular 4x4. I have upgraded the drive train and now put in a 1/8 cc system. To do that I had to move the receiver to...
  7. Replies
    3
    Views
    675

    if your talking the degree of the rudder to the...

    if your talking the degree of the rudder to the boat it is 90 degrees (straight up and down) altering it will adjust the attitude of the boat in corners.

    you asked this on facebook group too no?...
  8. Replies
    11
    Views
    2,445

    yes I have puffed batteries too the M41 really...

    yes I have puffed batteries too the M41 really pulls a lot of current. what you can do is start with shorter run times. Add a minute each time until you get to the point where the batteries are...
  9. Thread: Bearings

    by Gman313
    Replies
    6
    Views
    349

    What you can do is get a dental pick, pack them...

    What you can do is get a dental pick, pack them with either marine grease or wheel bearing grease and replace the seals. For mudding and water running you should get several runs before they seize up...
  10. What I was trying to see between the two posts: ...

    What I was trying to see between the two posts:

    Personally, I feel 25c is too low and 50c minimum, preferably 90c for me. My opinion only.

    However, despite what I am saying above the Traxxas...
  11. yep - they are a high quality battery though and...

    yep - they are a high quality battery though and test closer to 50c. personally 50 is my absolutely minimum I prefer 90.

    the esc can pull up to 300amps. 90c x 5000mah batter can handle up to 450...
  12. Replies
    3
    Views
    662

    Page 18 of the manual has the info :) ...

    Page 18 of the manual has the info :)

    Continuous - 80amp
    peak - 300 amp
    BEC 6V
  13. Replies
    25
    Views
    3,679

    Thank you smogman!

    Thank you smogman!
  14. Replies
    25
    Views
    3,679

    that makes thing easy - anyone have the part #s?

    that makes thing easy - anyone have the part #s?
  15. That's the battery traxxas recommends, it really...

    That's the battery traxxas recommends, it really should work
  16. Replies
    13
    Views
    868

    Slashmaxxsummi is completely correct! ...

    Slashmaxxsummi is completely correct!

    Basically

    Step 1 - disconnect pinion from spur, it should roll freely

    Step 2 - set proper gear mes

    Step 3 - give er
  17. Replies
    21
    Views
    961

    Have fun! love my slash I've had rc's for years...

    Have fun! love my slash I've had rc's for years and its my favourite

    that, my m41 and 1/8 buggy racing


    ok I like them all

    :)
  18. Replies
    21
    Views
    961

    The thing with aluminum, It doesn't flex, it...

    The thing with aluminum,

    It doesn't flex, it bends or breaks and your done. Use it but only in the right spots. You want the weakest part to also be the cheapest. if you upgrade the weakest part,...
  19. Replies
    20
    Views
    777

    if you think you will want to upgrade to 3s...

    if you think you will want to upgrade to 3s fairly quickly consider getting it right away but turning the esc down so you don't have full power. Then you can learn to drive or upgrade the drivetrain...
  20. Replies
    21
    Views
    961

    yep - my rule of thumb is if it breaks once buy...

    yep - my rule of thumb is if it breaks once buy two, then you will slowly have a spare of everything that breaks. especially if your LHS is smaller and doesn't stock parts all the time
  21. Thread: RPM Arms

    by Gman313
    Replies
    11
    Views
    1,112

    see and I found my xdutys with the RPM arms are...

    see and I found my xdutys with the RPM arms are great. What doesn't work is the RPM hub carriers (rear) and whatever you call the thing at the front the axle goes through will bind with the Xduties.
  22. same with DJI. that's too bad support your...

    same with DJI. that's too bad

    support your Local Hobby SHOP!!
  23. Replies
    21
    Views
    3,953

    I agree with stampedeswag - you should be closer...

    I agree with stampedeswag - you should be closer to 40. stupid question but are you sure GPS is correct? Roll the truck back and forth and make sure there is no binding or grinding it should roll...
  24. careful using the battery though. once they are...

    careful using the battery though. once they are puffed they are dangerous. some will say its fine to run with slight puffing. your house to burn down so up to you of course....

    there is a...
  25. Replies
    6
    Views
    334

    nice set up squeegie!

    nice set up squeegie!
Results 1 to 25 of 130
Page 1 of 6 1 2 3 4