Search:

Type: Posts; User: spartantamer

Page 1 of 6 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    11
    Views
    343

    Hot Racing Dual Pickup Rudder Blade Blue M41...

    Hot Racing Dual Pickup Rudder Blade Blue M41
    Specs:
    Width at Top of Rudder Blade: 1.2" (31mm)
    Width at Bottom of Rudder Blade: 1.04" (26.5mm)
    Total Rudder Length: 5" (127mm)
  2. Replies
    1
    Views
    145

    Switching all to EC5 connectors would be better....

    Switching all to EC5 connectors would be better. Running an adaptor will create more problems for you.
  3. Replies
    11
    Views
    343

    Go to OSE and look up DCB M41 upgrades. Both of...

    Go to OSE and look up DCB M41 upgrades. Both of those rudders will fit the Spartan.
  4. Replies
    4
    Views
    602

    If you let off the throttle and give it few...

    If you let off the throttle and give it few seconds it should recover if it's Thermal shutdown.
  5. Replies
    2
    Views
    259

    That prop will work fine with that setup.

    That prop will work fine with that setup.
  6. Thread: Props

    by spartantamer
    Replies
    3
    Views
    364

    Octura x442 prop is close to same as stock

    Octura x442 prop is close to same as stock
  7. Replies
    3
    Views
    275

    The Seaking 180 is a good choice. It will handle...

    The Seaking 180 is a good choice. It will handle 6s on your Spartan with ease.
  8. Replies
    2
    Views
    521

    EC5 or bigger would be better.

    EC5 or bigger would be better.
  9. Replies
    5
    Views
    1,433

    Sounds like the coupler isn't tight.

    Sounds like the coupler isn't tight.
  10. You will have better results with a new cooling...

    You will have better results with a new cooling can.
  11. Replies
    7
    Views
    567

    Yes you can.

    Yes you can.
  12. Replies
    21
    Views
    9,193

    The Octura X442 is a good prop to run. You will...

    The Octura X442 is a good prop to run. You will need to sharpen and balance it.
  13. Replies
    6
    Views
    1,693

    Installed the ceramic bearings and everything...

    Installed the ceramic bearings and everything went and ran fine.
  14. Replies
    1
    Views
    769

    The electronics will work along with the rudder....

    The electronics will work along with the rudder. The strut is different.
  15. Replies
    6
    Views
    1,693

    That is the correct size. I have put a pair of...

    That is the correct size. I have put a pair of ceramic bearings in a friends Spartan that I got from Avid rc. Will keep you posted.
  16. Replies
    3
    Views
    770

    I would use some white marine grade silicone to...

    I would use some white marine grade silicone to fasten it to the hull. That's what I did for the tow hooks and works great. You can pic up a small tube at Home Depo. Use small stainless sheet metal...
  17. Replies
    39
    Views
    3,233

    FYI, You can use your fishing pole too retrieve...

    FYI, You can use your fishing pole too retrieve your boat.
  18. Replies
    5
    Views
    2,107

    Shorten up your run times.

    Shorten up your run times.
  19. Thread: Strut?

    by spartantamer
    Replies
    10
    Views
    1,248

    The stock trim tabs will work just fine. Start by...

    The stock trim tabs will work just fine. Start by adjusting them down about a 1 mm[that is between a 1/16 and 1/8] below the bottom of the hull. Also start with the batteries all the way forward then...
  20. Replies
    39
    Views
    3,233

    Google TRAXXAS SPARTAN cable upgrade and shorten...

    Google TRAXXAS SPARTAN cable upgrade and shorten your run times and grease before every run until you get a handle on it. I would give you part numbers but it's not polite to advertise on anothers...
  21. Thread: Strut?

    by spartantamer
    Replies
    10
    Views
    1,248

    Turn the boat upside down and lay a straight edge...

    Turn the boat upside down and lay a straight edge on the bottom of the boat. Measure between the straight edge and the drive dog and set the strut about 3.5 mm to 4mm to start with.
  22. Replies
    39
    Views
    3,233

    Upgrade to a different coupler and a 3/16 flex...

    Upgrade to a different coupler and a 3/16 flex cable. Take the plastic liner out of the stuffing tube. Make sure you leave a 6mm to 8mm gap between the strut and dog.
  23. Thread: Prop??

    by spartantamer
    Replies
    2
    Views
    869

    Some props have numbers where the prop nut goes.

    Some props have numbers where the prop nut goes.
  24. Thread: Strut?

    by spartantamer
    Replies
    10
    Views
    1,248

    Yes sir it is.

    Yes sir it is.
  25. Thread: Props

    by spartantamer
    Replies
    7
    Views
    1,803

    OCTURA M447 is a good speed prop. Also X452 but...

    OCTURA M447 is a good speed prop. Also X452 but only make a pass or two and then pull it in and check it.
Results 1 to 25 of 138
Page 1 of 6 1 2 3 4