Search:

Type: Posts; User: Icehawk

Search: Search took 0.02 seconds.

  1. Replies
    17
    Views
    792

    Finally broke a front a-arm, it split at the...

    Finally broke a front a-arm, it split at the forward mount. Considering the abuse I've heaped on the Rusty I have just been waiting for this to happen. I went ahead and got the HD "cold weather"...
  2. Replies
    17
    Views
    792

    Installed the Powerhobby motor and ESC fanset -...

    Installed the Powerhobby motor and ESC fanset - took just a couple of minutes to install. I should get a chance tomorrow to test them out under duress, I'll run the heavy tires and see if I can use...
  3. Replies
    14
    Views
    516

    Sure sounds like the ESC is messed up, I'd try...

    Sure sounds like the ESC is messed up, I'd try and warranty it. It's certainly possible an internal solder connection failed after a big G event.

    Does the steering servo operate from the Mamba or...
  4. Replies
    17
    Views
    792

    Bought an IR gun so I can figure out if it is the...

    Bought an IR gun so I can figure out if it is the ESC or the motor that overheats in our summer heat - my guess is probably both :(
  5. Replies
    14
    Views
    516

    Do you still have the stock motor you could swap...

    Do you still have the stock motor you could swap in to test? First thing, IMO, is to figure out if it is an ESC or motor issue. I'd be you are right about a connection though, a hard landing...
  6. Replies
    9
    Views
    385

    You can also get full sets on eBay from take-off...

    You can also get full sets on eBay from take-off Slash Platinums for ~$65. I did end up going with stiffer springs but they aren't terrible out-of-the-box for bashing.

    They have plastic caps but...
  7. Replies
    17
    Views
    792

    Alright made a few changes, mainly dropped to a...

    Alright made a few changes, mainly dropped to a smaller rear sway and finally set the end points on my servo. I'm not loving the angle of the conrod between the bellcrank and horn so I may try...
  8. Replies
    15
    Views
    702

    Is there a concern using aluminum hexes on...

    Is there a concern using aluminum hexes on plastic wheels? I know with these cars as we beef stuff up we move breakage elsewhere - I'm wondering if aluminum hexes are more likely to strip out wheels...
  9. Replies
    2
    Views
    385

    Slightly different question, is it just the...

    Slightly different question, is it just the center link that is different between the 2wd & 4wd models?
  10. Replies
    17
    Views
    792

    What did you do to your Rusty today?

    These threads usually get lots of good posts, lets get one going here too!


    First thing I did today was repair the problem I had yesterday - the original steering horn had stripped last week so I...
  11. Replies
    17
    Views
    717

    Flip the lever to 70/30, that way you have a lot...

    Flip the lever to 70/30, that way you have a lot more throttle to work with.
  12. Replies
    19
    Views
    1,031

    I bought the GTR shocks as I was a bit concerned...

    I bought the GTR shocks as I was a bit concerned the Ultra shock threads may have been damaged by the cap popping off. I added HR sways as well which combined for a nice upgrade. Seems like I could...
  13. Thread: Servo Died

    by Icehawk
    Replies
    10
    Views
    595

    Today I got both a brand new 2075 and a set of...

    Today I got both a brand new 2075 and a set of the gears in the mail from Traxxas - no plans on swapping it back in though, the $20 China steel gear servo in there is fine for now. If anything I...
  14. Replies
    19
    Views
    1,031

    After popping the top cap twice on a shock I...

    After popping the top cap twice on a shock I ordered some of the takeoff GTRs you can find on eBay, they should be here in a few days. Along with the steering servo the shocks are just not up to...
  15. Thread: Servo Died

    by Icehawk
    Replies
    10
    Views
    595

    Yeah, mine stripped yesterday on 2nd pack. Going...

    Yeah, mine stripped yesterday on 2nd pack. Going to call on Monday but I had a spare servo I put in to keep going today. Popped a shock cap but at least that was from a big hit, the servo died on a...
Results 1 to 15 of 15