Search:

Type: Posts; User: 222

Page 1 of 20 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    3
    Views
    37

    Nope not here. Been running the same spur/pinion...

    Nope not here. Been running the same spur/pinion gears for years now. No geese or any lubricant for that matter ever placed on either.
  2. Replies
    8
    Views
    427

    The center driveshaft has to have a bit of play...

    The center driveshaft has to have a bit of play to compensate for the chassis flexing. Itís normal for it to be like this. You wouldnít want it to be full length as it would place a lot of stress on...
  3. Replies
    12
    Views
    680

    I second MIP, and will add RDS. Both Iíve gotten...

    I second MIP, and will add RDS. Both Iíve gotten off eBay. The MIP hex drivers are great and they work well! Tight fit and they wonít strip your hex head screws out that is for sure. I also use...
  4. Thread: 26-T pinion

    by 222
    Replies
    3
    Views
    627

    If you canít fix the traxxas one, try Robinson...

    If you canít fix the traxxas one, try Robinson Racing pinions. Just make sure you get the right one for use with the stock plastic spur. I think I always bought the hardened steel ones myself.
  5. Replies
    4
    Views
    175

    Pull both rear shocks and check the shock shaft...

    Pull both rear shocks and check the shock shaft length on both. Maybe you got a wrong length one on one side from the factory. Also by pulling the shocks you can rule out any other possible hang up...
  6. Replies
    1
    Views
    132

    2 nitro traxxs t maxx trucks help

    No the receiver is not compatible with the transmitter. Youíll need a receiver made for that transmitter. Here is the one you want for the transmitter you have....
  7. Check the voltage of the battery that is not...

    Check the voltage of the battery that is not charging. Itís may be that itís old and has lost too much voltage. Hopefully the trickle charger they send you will work. A different charger from the...
  8. Replies
    15
    Views
    437

    If you are using the ez-start it may be the motor...

    If you are using the ez-start it may be the motor for it is going bad. In the past, and from my own experience, many will ditch the ez-start system and replace it with a pull start. This will free...
  9. Replies
    82
    Views
    12,952

    Nope not at all. The ESC will only use what it...

    Nope not at all. The ESC will only use what it needs. The more MAH, the more runtime. The better the C rating the more amps the battery can provide in conjunction with the MAH. The 9400ís will be...
  10. Replies
    13
    Views
    419

    Lower it as much as you can. Place the shocks on...

    Lower it as much as you can. Place the shocks on the outer most holes on the a-arms and the under most holes on the shock towers. Maybe try some different spring rates and also some different...
  11. Replies
    3
    Views
    228

    Maybe just a fluke. Iíve not seen very many...

    Maybe just a fluke. Iíve not seen very many transmission issues with the Revo line. Blown diffs are what most have issues with.
  12. Replies
    82
    Views
    12,952

    Cost effective 4s lipos for X-Maxx?

    For batteries, look into SMC batteries. They are good and have some larger ones that will give more runtime versus the ones you have listed. And they are a lot less expensive. They also sell some...
  13. Thread: 3s Lipo trouble

    by 222
    Replies
    2
    Views
    208

    You need to put the batteries into storage mode...

    You need to put the batteries into storage mode when you are done using them. Do not charge them to 100% then place them away. This will ruin lipo batteries if they are left for any extended period...
  14. Replies
    11
    Views
    362

    Yes 2s would be better for the stock motor/esc. ...

    Yes 2s would be better for the stock motor/esc. It will definitely run cooler on 2s. Iíve had my slash 4x4 geared for near 40-45mph on 2s. No that itís the fastest, just to give an idea. And I...
  15. Replies
    11
    Views
    362

    Also you say you ruined the previous motor and...

    Also you say you ruined the previous motor and esc with salt water. Have you checked all the bearings? They may be rusted as well. Check all the bearings in the wheel hubs, and the motor mount as...
  16. Thread: Servo specs?

    by 222
    Replies
    9
    Views
    250

    It the same one that comes stock in the larger...

    It the same one that comes stock in the larger Xmaxx. Itís specs are 365oz. Of torque and .17 sec speed. Plenty of turning power for the size of the smaller Maxx. Should have no issue turning even...
  17. Replies
    12
    Views
    554

    Nope they are not needed unless you plan on or...

    Nope they are not needed unless you plan on or have a power hungry servo like a savox, in which case just one is truly all that is needed. They help keep you from having brown our issues with your...
  18. Replies
    2
    Views
    76

    Stock gearing will work well. Just keep an eye...

    Stock gearing will work well. Just keep an eye on the temps.
  19. Highest C rated batteries on SMC website are 75c....

    Highest C rated batteries on SMC website are 75c. He must be speaking about the burst rating which is normally double the actual C rating making 75c(x2), 150c burst rating. Still sad to see he had...
  20. Replies
    14
    Views
    447

    Why not use a 2s lipo instead and leave it in...

    Why not use a 2s lipo instead and leave it in regular mode. This will slow it down compared to a 3s but still have enough power to be fun. 2s lipos are not very expensive these days and will allow...
  21. Replies
    12
    Views
    554

    Those do appear to be just a capacitor or like...

    Those do appear to be just a capacitor or like you said, a ďglitch busterĒ. They are used for keeping the esc from having brown out issues. Good for when you are using a power hungry servo like...
  22. Replies
    9
    Views
    791

    Donít see where he spoke about running in the...

    Donít see where he spoke about running in the mud. The older posts show running in mud, but not the newest one by OP. Not sure what his issue with the TX/RX and ESC/motor is. He has recalibrated...
  23. Replies
    4
    Views
    296

    The Big Bores should work just fine for general...

    The Big Bores should work just fine for general bashing. While not as large as the GTRís and donít have the second spring like the proline shocks do, the big bores will work just fine. You may have...
  24. I meant slipper clutch. Darn auto correct.

    I meant slipper clutch. Darn auto correct.
  25. Is your spiller clutch possibly loose? Check the...

    Is your spiller clutch possibly loose? Check the slipper clutch tightness. That or your gear mesh isnít set correctly.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4