Search:

Type: Posts; User: Acidic01

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    3
    Views
    100

    On my 2x4 I put a castle 4600kv and a mamba x...

    On my 2x4 I put a castle 4600kv and a mamba x esc... A bit spendy but what lhs had and was a kit... I've yet to tune it with castle card. Thing flys and I run out of space to see top speed....
  2. No it should be just fine. Sent from my Pixel...

    No it should be just fine.

    Sent from my Pixel 3 XL using Tapatalk
  3. Replies
    12
    Views
    752

    I use smc. I have not had any issues with them....

    I use smc. I have not had any issues with them. Have them from my merv , rustler, erevo and xmaxx...

    Lectron pros 3s I got sucked and didn't last long before they would hit lvc stage 1 on wot...
  4. Replies
    6
    Views
    235

    For the roll overs let off the throttle when...

    For the roll overs let off the throttle when turning. Can pre load the springs some but won't really help on this issue. Just learn how to drives.

    Can't help on the proline body as never had...
  5. Adjust your servo end points so that it stops...

    Adjust your servo end points so that it stops before hitting the mechanical stops.


    Make sure that tsm is turned off completely...

    Sent from my Pixel 3 XL using Tapatalk
  6. Have you put the car back together and see how...

    Have you put the car back together and see how the tires go? It may just be that the bell crank is just not seated with the skid plate and screwed in.

    When I watch the vid and look at the...
  7. In your vid I don't see a issue..... But...

    In your vid I don't see a issue..... But perhaps I'm just not seeing it...

    Sent from my Pixel 3 XL using Tapatalk
  8. Replies
    15
    Views
    251

    These could work well too. I don't think I...

    These could work well too. I don't think I found these or were out of stock when I was looking for one.

    Sent from my Pixel 3 XL using Tapatalk
  9. Replies
    15
    Views
    251

    I did the homemade wood ramp thing. Made a few...

    I did the homemade wood ramp thing. Made a few iterations. Was straight but flexed into a curve.

    I needed a portable ramp to carry the few blocks to the local park. Something the legs would...
  10. Replies
    8
    Views
    236

    The diff housing will have some grease. Stock it...

    The diff housing will have some grease. Stock it doesn't have much. But inside the diff should be silicone oil. Some people have put grease inside the diffs... But ideal to put the right at oil...
  11. Replies
    13
    Views
    270

    Check the esc button. Also I would open up the...

    Check the esc button. Also I would open up the rx box and remove the servo wires. And fans. And see if it comes on.



    Sent from my Pixel 3 XL using Tapatalk
  12. Replies
    8
    Views
    236

    I have 150k in my merv. 500k in my xmaxx and...

    I have 150k in my merv. 500k in my xmaxx and once I put in my *** diff into my 2wd rustler I'll put 100k to 200k in that.

    I like a more locked diff. Seems to do well for bashing for me.
    ...
  13. Replies
    8
    Views
    236

    Almost looks like super dirty think oil...

    Almost looks like super dirty think oil [emoji2369]

    I like marine grease on my gears and and bearings but I play in water and the beach...

    Sent from my Pixel 3 XL using Tapatalk
  14. Replies
    8
    Views
    295

    https://forums.traxxas.com/showthread.php?p=656425...

    https://forums.traxxas.com/showthread.php?p=6564257

    Sent from my Pixel 3 XL using Tapatalk
  15. Replies
    20
    Views
    526

    There are two. 6s version with a vxl6s and...

    There are two. 6s version with a vxl6s and wanna say 1600kv motor and different diffs and a slipper clutch.

    Then 8s with vxl8s esc and 1200kv motor and bigger diffs and a cushdrive vs...
  16. Replies
    3
    Views
    273

    Nice. Like it. Sent from my Pixel 3 XL...

    Nice. Like it.



    Sent from my Pixel 3 XL using Tapatalk
  17. Replies
    13
    Views
    270

    If ran in water recently,. Or hosed the car off. ...

    If ran in water recently,. Or hosed the car off. Check the rx to make sure no water in there. And if so let it dry out. Also make sure the motor temp sensor is plugged in. As truck won't work...
  18. Replies
    5
    Views
    146

    +1 on this. Keep a big eye on temps and adjust...

    +1 on this. Keep a big eye on temps and adjust up and down according.

    Sent from my Pixel 3 XL using Tapatalk
  19. Replies
    8
    Views
    295

    Not to distract but this topic has been covered...

    Not to distract but this topic has been covered multiple times in detail. Check out the search function. Lots of good info already discussed.


    Most use a max 5 and 800kv motor. The...
  20. Replies
    12
    Views
    293

    The body support you can buy from home depot or...

    The body support you can buy from home depot or the like. Comes in a 2ft or 3ft piece you then cut down.

    Sent from my Pixel 3 XL using Tapatalk
  21. Replies
    7
    Views
    213

    I think the two lines are fine... On my...

    I think the two lines are fine...

    On my erevo I got 2 wrapped as that's what made sense for the badlands.

    On xmaxx I just did one. As that's what worked for the stock tires.

    Both seem to...
  22. Any brand will work for the oil. You can...

    Any brand will work for the oil. You can probably fill 10 to 15+ diffs or more with a 2oz bottle. As it doesn't take very much.

    I fill it up till the spider gear are covered. I put some...
  23. Replies
    12
    Views
    293

    This is what I would do if I still had a stock...

    This is what I would do if I still had a stock body...... I missed my body to go over the rear bumper

    As over time the tailgate will bend over the rear shock towers and break the body...
    ...
  24. On a titan motor I don't think you will get to...

    On a titan motor I don't think you will get to high of temps to need a fan. Perhaps a heat sink. As a 2s lipo won't push it that hard... Imho

    I've seen where people go to a metal diff housing...
  25. If constantly adjusting steering trim servo horn...

    If constantly adjusting steering trim servo horn may be slipping teeth.

    Of the servo save thing is slipping

    I put a different steering assembly on my rustler from the 4x4 version may also be...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4