Search:

I am curious to what you find. I snapped a 3mm shaft on a CC 3800 motor. Now I'm looking to replace it with a new sensored CC 2400 5mm shaft motor. I have a 50T mod 0.8 that I can use. So, I just...

That's pretty ganster Milt. Have you ran it yet. I bought a used one a while back, then the saga conversion. I just need to assemble it yet.

I have a slash 4X4 that does 114mph all day long on 6S if that interests you

Initially there was some interest...no one wants a well built rig?

Bumpity bump

Up, up, and up.

Keeping it fresh

To. The. Top.

I'd say look here to get a rough idea of what used prices are. My 2$, prices vary depending on condition and stock vs how modified and why modifications are done...I'd say ask this quiz the Slash 4x4...

That's kinda high for a stock used one...I'm also pretty sure a moderator is going to tell ya this conversion does not belong in the marketplace

This started as a platinum slash LCG 4X4 with the newer Traxxas 4-pole motor and ESC. I built it for my 7 year old who just never really got into it. It was built to be uber durable. PM me if you...

I would like to purchase these. I will DM you or, txt me @ three three zero - seven zero four - two six two seven

I'm interested in the 4tec... what are you asking for it shipped to Ohio? 44708

Small word of advice, don't go tekno big bone for speed runs. It vibrates like crazy and ends up moving around almost a inch during its cycle... Great for bashing...bad for speed runs... Oh. It don't...

I had the tenko big bone too, it vibrated like crazy at high speeds. Went back to stock and vibrations are gone...

I have all metal pinion spur combos in my high power rigs with no issues... My experence is it OK as long as mesh is OK... The most aggressive gearing I was able to obtain on stock Slash setup was...

Your going to see more speed builds in the Rally section. I have one there and there are two others currently going too

Nice work! Keep pushing. What gearing ratio ate you using?

I don't recall what brand gear it is... I've found even a plastic spur held up... Just got to have gear mesh correct.

have the bulkheads been installed previously?

I run my Traxxas 2200Kv (rebranded Castle) on 8S... one to two passes then let her COOL OFF for a bit. It'll take it, just not pass after pass after pass...

THANK YOU ALL for your compliments.



My thought is more voltage and more gearing. Maybe a 6S for a pass, 2 at the most before you let it cool. The motor is going to be HOT... Your gearing is...

My 2¢ would be to use the mip 17mm hexes. I've been running almost the same setup with them and zero issues. I'm not easy on it either...

Rock solid. No shimmy or wondering. No lift either. There is more left in her too. I didn't use all of the available road. Going to let her stretch her.egs next time out. I still have more gearing...

Body's done. Shoe goo and dry wall tape then fiberglass mat with resin.

http://i1268.photobucket.com/albums/jj565/rockyharis/2015-09/BBFB5D06-0562-4B71-96ED-9B5008F68526_zpsu4tq7izj.jpg
...