Search:

Type: Posts; User: 222

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    21
    Views
    1,046

    If you want really good servos and donít mind...

    If you want really good servos and donít mind spending for one, look at MKS servos. They have one that is 900oz plus. Not cheap though at nearly $200.


    Sent from my iPhone 11 Pro Max using...
  2. Replies
    3
    Views
    885

    Max Amp batteries are overrated and way over...

    Max Amp batteries are overrated and way over priced. SMC makes some high MAH batteries that fit the summit. 8000mah batteries for under$42.95.


    Sent from my iPhone 11 Pro Max using Tapatalk...
  3. Replies
    1
    Views
    339

    Have you tried to tighten the slipper clutch? If...

    Have you tried to tighten the slipper clutch? If not, itís the small nut in front of the spur gear. You may have glazed the clutch pads. If tightening the slipper clutch doesnít work, check the...
  4. Looks like a capacitor pack. Or what some call a...

    Looks like a capacitor pack. Or what some call a ripple killer. Benefit is that it delivers smooth electrical flow, which in turn both enables your ESC to work more efficiently in sending power to...
  5. Thread: New to lipos

    by 222
    Replies
    4
    Views
    646

    Yes youíll need to run dual 2s lipos with the...

    Yes youíll need to run dual 2s lipos with the summit. There is no limit to how much MAH you can use. The ESC will only draw what it needs. Both batteries need to be the same MAH, same C rating and...
  6. Replies
    11
    Views
    834

    Donít leave out the Reefís Triple 4 or Triple 5...

    Donít leave out the Reefís Triple 4 or Triple 5 servos. Thereís a YouTube vid floating around that shows the massive power they can produce. Not cheap though.


    Sent from my iPhone 11 Pro Max...
  7. Replies
    7
    Views
    522

    First let me ask why are you wanting to do this??...

    First let me ask why are you wanting to do this?? And as for switching gears, itís Either through the optidrive device or RPMís. Never heard of anyone wanting to switch a slash 4x4 to 2 speed...
  8. Thread: Battery maximum

    by 222
    Replies
    4
    Views
    513

    A 100c battery will not damage anything. The ESC...

    A 100c battery will not damage anything. The ESC will only use what it needs. As for a 6s lipo X2, no that would be way too much voltage and just throw the ESC into over voltage. Use 2 x 4s...
  9. Replies
    4
    Views
    849

    Agreed. Going down in wire size is not what you...

    Agreed. Going down in wire size is not what you want to do. This will create a bottleneck and cause heat issues and possibly damage your electronics due to inadequate power getting to the esc. As...
  10. Replies
    12
    Views
    674

    Leave it bare man! Looks very nice as it sits!...

    Leave it bare man! Looks very nice as it sits! Keep up the great work!! Love the bowling bowl! Had an old low rider painted bowling bowl green. Nice to see itís still a cool way to paint!

    ...
  11. Replies
    3
    Views
    125

    With the front end being so light your going to...

    With the front end being so light your going to get lifting. You can try and add a spoiler made of Lexan on the front end. I believe the rustler speed run guys use a brass weight to keep the front...
  12. Thread: Upgrades

    by 222
    Replies
    44
    Views
    740

    Man this dude just doesnít seem to grasp the idea...

    Man this dude just doesnít seem to grasp the idea of self reliance in any sense of the term. We are not babysitters here and yes there are some DARN knowledgeable folks on this forum. You are...
  13. Replies
    11
    Views
    693

    Megawatt makes a darn good power supply. You can...

    Megawatt makes a darn good power supply. You can get a 400w one for $60. A 350w one is only $50. I use these power supplies for my HF radios and they are clean power and can go up to 15v. I ran...
  14. Here is what is says about slow blinking red. ...

    Here is what is says about slow blinking red.

    Slow Blinking Red (with Low-Voltage Detection on): The VXL-3s has entered Low-Voltage Protection. When the battery voltage begins to reach the...
  15. Replies
    7
    Views
    388

    The magenta may be glazed in the motor from...

    The magenta may be glazed in the motor from excessive heat caused by a bad bearing or running 3s WOT without monitoring temps. Either way the motor may need to be rebuilt on the inside. New rotor...
  16. Replies
    6
    Views
    691

    Yep if you are going through spur gears there is...

    Yep if you are going through spur gears there is definitely an issue. As said check motor mount, bearings, and related parts. I will also add that I have had the same spur gear on both my summit...
  17. Replies
    7
    Views
    332

    Same here. Get the aluminum shaft and man please...

    Same here. Get the aluminum shaft and man please take care of the rust. It will come back to bite you in the rear if you donít.
  18. Thread: Dog Bones and Cups

    by 222
    Replies
    7
    Views
    362

    It looks like the end that slides into the...

    It looks like the end that slides into the outdrive cups is missing the pin or part that keeps it in place inside the outdrive cup as pictured here on the right end of them....
  19. Do yourself a favor and ditch at least the blue...

    Do yourself a favor and ditch at least the blue wire to the low plug and get yourself a proper glow plug ignitor. Then you can remove the glow plug and plug it into the ignitor very quickly and see...
  20. Donít personally have the link. Just the app on...

    Donít personally have the link. Just the app on my phone. You can enter the app and get into some settings without having a Bluetooth link. I would highly recommend one though as they make things...
  21. Thread: Help please?

    by 222
    Replies
    9
    Views
    536

    Well at least you made some headway about the...

    Well at least you made some headway about the issue. I will say that a sensor less brushless motor will cog a little on take off. Itís normal and youíll experience it more as you gear up. ...
  22. Replies
    134
    Views
    16,150

    Wow!! You scored man!! Where do you live LOL!!

    Wow!! You scored man!! Where do you live LOL!!
  23. Thread: Help please?

    by 222
    Replies
    9
    Views
    536

    If all other stuff you have done isnít helping,...

    If all other stuff you have done isnít helping, as said, check the motor wires for solid connection to esc. If that doesnít help, I would think that the only option left is to update the ESC. If in...
  24. Replies
    10
    Views
    694

    Iíve seen where some get around this by mounting...

    Iíve seen where some get around this by mounting the esc into one of the battery bays. You may have to mod the chassis for this as well. But itís the only way Iíve seen a larger esc like yours be...
  25. Replies
    5
    Views
    363

    Even tightening the stock screws too tightly can...

    Even tightening the stock screws too tightly can affect the way the diff works. Been there and done that.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4