Search:

Type: Posts; User: Double G

Page 1 of 20 1 2 3 4

Search: Search took 0.26 seconds.

  1. Replies
    179
    Views
    9,774

    The break in period is hard on a clutch so it...

    The break in period is hard on a clutch so it does let go what seems prematurely. Did the spring break or the shoe at the pin? Spend the $8 (last time I looked they were this price…been so long)...
  2. Replies
    179
    Views
    9,774

    Optidrive connects to the receiver and the...

    Optidrive connects to the receiver and the throttle and shift servos connect to it. If the OD has issues then there is the possibility that the throttle will not get the input(s) and the truck runs...
  3. Thread: driveshafts

    by Double G
    Replies
    3
    Views
    118

    I've never thought of the transmission being a...

    I've never thought of the transmission being a pain to remove/reinstall. To each their own. Remove each of the center shafts from the output shaft and see if the issue is in the transmission or...
  4. If you have nothing nice to say, then don't say...

    If you have nothing nice to say, then don't say it. Feel free to disagree with someone else's opinion, but outright attacks against the individual and their character are not allowed here.


    ...
  5. Replies
    1,203
    Views
    191,589

    Look at the rear wheel flare - you can see the...

    Look at the rear wheel flare - you can see the tape is inside the body. Plus, look at the whole side: tape doesn't reflect and shine like that.
  6. Well, your boredom should be gone now.

    Well, your boredom should be gone now.
  7. Replies
    9
    Views
    231

    Look again.

    Look again.
  8. Most of the mods are volunteer and not Traxxas...

    Most of the mods are volunteer and not Traxxas employees. Since this is on my own time - outside of my family and work commitments - I will not be on here 24/7 to everyone's beck and call. I do try...
  9. Replies
    4
    Views
    148

    No need to freak out. It has been. As well as a...

    No need to freak out. It has been. As well as a few other subforums.


    Also, no need to hit the “report post” button unnecessarily.
  10. Today? A fart in the wind...so far. 2011 was a...

    Today? A fart in the wind...so far. 2011 was a silent but deadly in a small enclosed room with no windows or doors.
  11. There may be changes happening in the background....

    There may be changes happening in the background. Admin is aware. Please be patient.
  12. Replies
    179
    Views
    9,774

    I still tune it at half a tank.

    I still tune it at half a tank.
  13. Replies
    42
    Views
    4,077

    I have both Duratrax and Proline tires...Duratrax...

    I have both Duratrax and Proline tires...Duratrax 2.8 for my Slashes and Proline 3.8 for the nitro Revo. I am much more impressed with the Prolines than the Duratrax.
    On the Revo, the Badlands are...
  14. Replies
    17
    Views
    2,639

    In all the years I've been here this would be the...

    In all the years I've been here this would be the first that I've heard of an internal failure of the GTR shock - any GTR shock for that matter.
  15. Replies
    179
    Views
    9,774

    My nitro Revo has been extremely reliable for the...

    My nitro Revo has been extremely reliable for the past 10+ years. Replaced a couple servos, an a-arm, clutches, engine(s), exhaust pipe and bearings.
  16. Replies
    22
    Views
    894

    It should. Take the throttle servo and/or...

    It should. Take the throttle servo and/or steering servo and plug into CH3 to see if they work when flipping the switch. Plug the reverse servo into CH1 or 2 and see if it works.

    The opti-drive...
  17. Replies
    22
    Views
    894

    Plug the reverse servo directly into Ch3 in the...

    Plug the reverse servo directly into Ch3 in the receiver.
  18. Replies
    6
    Views
    144

    If you bench-tested it with no load and it still...

    If you bench-tested it with no load and it still got hot then you've found your problem. Do you have another ESC/motor combo to rule out the ESC?
  19. Replies
    179
    Views
    9,774

    Awesome! For tuning, don't turn both needles...

    Awesome!

    For tuning, don't turn both needles at the same time. Tune the HSN and then the LSN. If you haven't already, cut a hole in the windshield in front of the cooling head to allow air to...
  20. Replies
    179
    Views
    9,774

    I may have mentioned before, I set the idle and...

    I may have mentioned before, I set the idle and leave it. A properly set LSN will allow the engine to idle low enough, cool off and not engage the clutch.
  21. Replies
    13
    Views
    761

    What I'm about to say is not directed towards any...

    What I'm about to say is not directed towards any particular individual in this thread or on the board.

    Just remember that we get one side of the story. It is extremely rare that we hear the...
  22. Replies
    22
    Views
    894

    Tuning takes some time to get the hang of. ...

    Tuning takes some time to get the hang of. Traxxas's factory settings are just that - a starting point to get the engine running then you tune for smoke and performance. IMHO, the HSN is on the...
  23. This needs to be done. What has been described...

    This needs to be done. What has been described is a slipping one-way bearing as the OP mentioned that the motor sounds like it is spinning but the engine is not. In their nitro manuals, Traxxas...
  24. Thread: Dies at idle

    by Double G
    Replies
    16
    Views
    1,421

    < drops mic > :lol:

    < drops mic > :lol:
  25. You didn’t gear it down by going from 90t to 86t;...

    You didn’t gear it down by going from 90t to 86t; you geared up. Also, there is a strong advisement from Castle (as posted on their site and in the manual) that the system is recommended for a max...
Results 1 to 25 of 495
Page 1 of 20 1 2 3 4