Search:

Type: Posts; User: Norco

Page 1 of 3 1 2 3

Search: Search took 0.02 seconds.

  1. Replies
    39
    Views
    1,073

    either garden hose if im at home or i fill a...

    either garden hose if im at home or i fill a container full of water and take the tires off and just dunk the thing viciously swooshing it around lol, let air dry or hang it in front of a fan for...
  2. Replies
    2
    Views
    226

    temp gun question

    nevermind figured it out LOL. The gun button for C and F was sticking and kept changing between F and C when i took reading of one thing then the other thinking both was Celcius. :rolleyes: so...
  3. Replies
    2
    Views
    226

    temp gun question

    so i just did 2 speed runs with my slash 4x4 with 3 cell lipo and 54/18 gearing and my temp gun read 125 celcius which is 257 F, the 3500 says shouldnt go above 200F lol, i think my gun is accurate...
  4. Thread: rebuilding motor

    by Norco
    Replies
    7
    Views
    353

    yeah looks like just gonna buy another motor, ill...

    yeah looks like just gonna buy another motor, ill have to check it sooner next time lol, after reading about it now most seem to rebuild them after 6 months to a year it seems, this motor been almost...
  5. Thread: rebuilding motor

    by Norco
    Replies
    7
    Views
    353

    rebuilding motor

    motor started to bind so took it apart and well the bearings fell apart, but i notice taking the rotor out bunch of copper wire is frayed/unwinding from the walls, does that matter? sliding the rotor...
  6. Replies
    2
    Views
    550

    shorted lipo for split second

    sooo i was checking individual cell voltage with the balance plug and my hand slipped and im pretty sure i shorted it for a split second(pins so tiny lol), i heard a slight puff sound and very small...
  7. Replies
    2
    Views
    362

    whats the trick aligning the drive shafts when...

    whats the trick aligning the drive shafts when attaching the front end, i thought the mini erevo was pain, this worse lol
  8. Replies
    2
    Views
    362

    well i took it apart, appears its always been...

    well i took it apart, appears its always been locked lol, the sprocket that slides over the pinion with the pin doesn't fit, i had to pry it off, watched some videos and the sprocket should just...
  9. Replies
    2
    Views
    362

    front diff appears to be stuck locked

    was gonna take it out for a rip and noticed a slight whine when front diff was disengaged so was gonna try adjust the servo but it appears its stuck locked, when the servo is disengaged(pulls the rod...
  10. Replies
    10
    Views
    604

    so i decided to just take motor out and run it...

    so i decided to just take motor out and run it loose and sounds fine, appears its noisy when its under a load(driving the wheels when i have it upside down)
  11. Replies
    10
    Views
    604

    cleaned it out, appears to be good now, almost...

    cleaned it out, appears to be good now, almost seems better than when it was new, but motor pretty noisy now, dont wanna buy another can of spray, i used a whole can on it already lol
  12. Replies
    3
    Views
    515

    ended up using couple pairs of pliers, and just...

    ended up using couple pairs of pliers, and just pulled, man those things were on there good but came off
  13. Replies
    3
    Views
    515

    i cant disconnect the motor wires lol

    like the title says im having a **** of a time disconnecting the motor wires from the esc, are they locked somehow, if i pull any hard im gonna break something <_<
  14. Replies
    10
    Views
    604

    lacking power it seems

    took the summit out and seemed kinda sluggish than normal, thought maybe my lipos so i tested them in my slash and they appear to be fine, if i had to give it a percent id say maybe lost 20% power...
  15. Replies
    7
    Views
    7,793

    appears i may have same problem, i hope it works...

    appears i may have same problem, i hope it works after it dries out, the thing is my receiver box and the piece with the foam were both missing a screw on one side, thought maybe fell out but when i...
  16. Replies
    3
    Views
    741

    well i gave it a bath dried it out and running it...

    well i gave it a bath dried it out and running it indoor, seems to be fine now, maybe water got into esc, or didnt like the ice cold water, who knows see what happens next time take outside,...
  17. Replies
    3
    Views
    741

    question about forward/reverse delay

    so i picked up a slash back at xmas and finally took it out today, was wondering whats normal for delay going forward then reverse and vice versa, i appear to have to come to a FULL stop and then...
  18. Replies
    427
    Views
    62,408

    sure dont give ya much time to edit a post lol...

    sure dont give ya much time to edit a post lol but here post again as i had to change the address

    http://i164.photobucket.com/albums/u30/koolnestea/IMG_0014_zps9c73dd1a.jpg...
  19. Replies
    427
    Views
    62,408

    took it for a night rip in the snow, here what it...

    took it for a night rip in the snow, here what it looked like after lol

    http://i164.photobucket.com/albums/u30/koolnestea/IMG_0013.jpg
    ...
  20. Replies
    5
    Views
    576

    get quite a bit more traction putting the dirt...

    get quite a bit more traction putting the dirt hawgs on backwards lol
  21. Replies
    5
    Views
    576

    snow chains on talons or dirt hawgs?

    so winter is here and well erevo is pretty pitiful with the talons or dirt hawgs so was gonna chain a set but not sure which one i should, thinking dirt hawgs since they narrow and taller tire, was...
  22. Replies
    9
    Views
    520

    i just finished charging the 2nd 7600 pack, it...

    i just finished charging the 2nd 7600 pack, it only took 7173 mah (vs 7844 first pack), is that too much diff from the other pack, or normal since u said the bec side would use more power?
  23. Replies
    9
    Views
    520

    well i just charged one of them and the battery...

    well i just charged one of them and the battery took 7844mah so i guess i cant complain as its a 7600 mah battery lol, just found it odd that its resting voltage was 3.7 voltage, wonder how much mah...
  24. Replies
    9
    Views
    520

    wonder if i woulda got higher discharge rating if...

    wonder if i woulda got higher discharge rating if would cut off as early, the 7600s i got were only 25C which is enough but the ones i got for my erevo vxl are 40C and 50C so prolly keeps a more...
  25. Replies
    9
    Views
    520

    you'd think be ok on snow/ice since the front and...

    you'd think be ok on snow/ice since the front and rear wouldnt be fighting each other at all since the tires just spin anyway, you prolly get more snow there on avg but prolly gets colder here, been...
Results 1 to 25 of 65
Page 1 of 3 1 2 3