Search:

Type: Posts; User: FnFancy

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Thread: LCG chassis

    by FnFancy
    Replies
    3
    Views
    115

    The lcg chassis does absolutely fine in extreme...

    The lcg chassis does absolutely fine in extreme off road situations. You actually dont loose any ground clearance, there's nothing to loose and all to gain.

    Sent from my SM-N960U using Tapatalk
  2. Thread: Im giving up!

    by FnFancy
    Replies
    15
    Views
    587

    I've sent my 2.0 big, and this never happened. I...

    I've sent my 2.0 big, and this never happened. I did break the chassis, but not to the extent shown here. I agree, something is missing from the story!

    Sent from my SM-N960U using Tapatalk
  3. I chuckled for you. When I first started in this...

    I chuckled for you. When I first started in this hobby, I was a lost little lamb. I would take things apart and not remember how to put it back together! The exploded views are a great tool, after...
  4. Do you have a picture of the spur? I'd be willing...

    Do you have a picture of the spur? I'd be willing to bet money its toast. Luckily spur gears are cheap! You mentioned speed bumps, while it doesn't send the truck flying, if you hit them with some...
  5. Replies
    6
    Views
    223

    If its badged as a mamba max it falls into this...

    If its badged as a mamba max it falls into this category. Post a pic, it will help identify...
  6. Replies
    4
    Views
    172

    Welcome to the forum and congratulations on your...

    Welcome to the forum and congratulations on your new 2.0! Read up on the forum, most issues have been covered so far. Basics are sync the servos, get an aluminum rear brace and watch your temps. From...
  7. Ha, that's my neck of the woods! I've tried...

    Ha, that's my neck of the woods! I've tried hobbywing, while I didn't have major issues I don't think I'll go there again. LVC issues and I couldn't keep the fan working for the life of me which led...
  8. Right! I actually haven't taken her out in a...

    Right! I actually haven't taken her out in a while. Need a new body and figure out the electrical issue.

    Sent from my SM-N960U using Tapatalk
  9. Check bearings, monitor motor/ esc temps, check...

    Check bearings, monitor motor/ esc temps, check pillow balls, rod ends and rotate axle cups (this prolongs the inevitable "notch " that will develop)

    Sent from my SM-N960U using Tapatalk
  10. Deja vue any one? I feel like we've had this...

    Deja vue any one? I feel like we've had this conversation before! To the OP, ALL RC VEHICLES WILL BREAK! No matter if it's a $200 RTR traxxas or a $600 kit that doesn't include electronics. When all...
  11. Takes some practice, especially when you get it...

    Takes some practice, especially when you get it perfect and you tighten your mount screw down and it gets thrown off.

    Sent from my SM-N960U using Tapatalk[/QUOTE]

    Haha, I loath that! You take...
  12. Recommend watching some youtube videos on setting...

    Recommend watching some youtube videos on setting gear mesh. A plastic spur can and will last years when set properly.

    Sent from my SM-N960U using Tapatalk
  13. Actual drive line failures are not very common on...

    Actual drive line failures are not very common on this vehicle. That doesn't mean it won't break though, like any rc vehicle if you drive with no control, eventually something will break. Its always...
  14. Replies
    6
    Views
    223

    Mamba max! I remember now, how old is the esc? I...

    Mamba max! I remember now, how old is the esc? I had an older mamba max with the same issue. When I called castle they informed me the mamba max does not work with the new versions of castle link and...
  15. Replies
    6
    Views
    223

    Did you install the software on your computer? ...

    Did you install the software on your computer?

    Sent from my SM-N960U using Tapatalk
  16. Replies
    10
    Views
    209

    Perfect, then definitely stick to the traxxas...

    Perfect, then definitely stick to the traxxas 17mm conversion. I have them on my rusty and never encountered any problems. Well, just make sure to locktite the barrel nut and check every so often...
  17. Replies
    4
    Views
    74

    I'm by no means a traxxas battery fan boy but to...

    I'm by no means a traxxas battery fan boy but to be fair, I've have traxxas batteries that I still use that are over three years old. And no, 2s will not be faster than a 8.4 nimh battery. A fully...
  18. Replies
    10
    Views
    209

    Then just stick with the traxxas 17mm adapters. I...

    Then just stick with the traxxas 17mm adapters. I can't really see the drive shafts, are they the stock plastic ones?

    Sent from my SM-N960U using Tapatalk
  19. Replies
    10
    Views
    209

    It's hard to tell, are those mip axles? If so, go...

    It's hard to tell, are those mip axles? If so, go with hot racing adapters. Tires for speed runs I'm not well versed on. Some one will chime in with the necessary knowledge I'm sure.

    Sent from my...
  20. Replies
    5
    Views
    192

    The rpm arms are the reason your shaft pops out,...

    The rpm arms are the reason your shaft pops out, on the flip side rpm arms can flex enough to break the tekno shafts by compression. Not saying it can't be done, but tekno themselves state not to use...
  21. Replies
    4
    Views
    74

    A 2s lipo is very comparable to the stock battery...

    A 2s lipo is very comparable to the stock battery voltage wise. If your not over heating now, you won't with the lipo. The only difference is run time. So the heat can build up due to running longer....
  22. Replies
    10
    Views
    209

    Haha, done!? Maybe for now, eventually something...

    Haha, done!? Maybe for now, eventually something will break and then it gets upgraded! On a serious note, a beautiful rusty you've got there, almost too pretty. Go out and thrash that thing. If you...
  23. Replies
    12
    Views
    488

    To recap, you want to build a drag car from a 2wd...

    To recap, you want to build a drag car from a 2wd slash. That means straight line high speed pass over short distance with cool down period in between. If this is the case, shorten the a arms (bandit...
  24. Replies
    12
    Views
    488

    What batteries will you be running? 2s or 3s? How...

    What batteries will you be running? 2s or 3s? How heavy is the truck? What gearing?

    Sent from my SM-N960U using Tapatalk
  25. Quick Google search brought up this from castle...

    Quick Google search brought up this from castle creations. https://uploads.tapatalk-cdn.com/20190626/6034f6419f0c0c35c5a24e4cd8f33338.jpg

    Sent from my SM-N960U using Tapatalk
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4