Search:

Type: Posts; User: dgechrgr469

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. I have used the Flex Seal tape, it conforms to...

    I have used the Flex Seal tape, it conforms to weird shapes and is very tough. I used it to reinforce cracked bodies and to protect the paint finish on the inside of the body from tire and nerf bar...
  2. Replies
    7
    Views
    181

    I think it would work but i'd make another hole...

    I think it would work but i'd make another hole to "vent" that you could plug after filling to prevent from grease/air being forced out of anywhere it could.

    Sent from my VS996 using Tapatalk
  3. Replies
    3
    Views
    116

    The Slayer shock bodies are roughly 3/10 shorter...

    The Slayer shock bodies are roughly 3/10 shorter than rear Slash shocks. Front slash shocks are slightly shorter than Slayer shocks. I'm not sure if the shock rods are a different diameter between...
  4. Replies
    3
    Views
    116

    I would say the shock bodies would be shorter too...

    I would say the shock bodies would be shorter too so I think all new shocks are in order. I have both at home so if no one else knows I can check mine later.

    Sent from my VS996 using Tapatalk
  5. Replies
    4
    Views
    84

    Oops guess the brand with star at the end is...

    Oops guess the brand with star at the end is banned.

    Sent from my VS996 using Tapatalk
  6. Replies
    4
    Views
    84

    Hobbywing, Skyrc, Goolrc, *********, Dynamite...

    Hobbywing, Skyrc, Goolrc, *********, Dynamite i've used that are less expensive than Tekin, Castle etc which i've also used.

    Sent from my VS996 using Tapatalk
  7. Whatever car/truck you have please post it in the...

    Whatever car/truck you have please post it in the correct forum and you should get plenty of responses.

    Sent from my VS996 using Tapatalk
  8. Replies
    4
    Views
    84

    There are several online retailers that sell good...

    There are several online retailers that sell good bramds of esc/motor combos. I could mention brands but you'll always get someone who had a bad experience with it. Make sure you get a esc/motor...
  9. Replies
    7
    Views
    174

    A lot of hobby shops are limited to what their...

    A lot of hobby shops are limited to what their distributor sells, any retailer rarely buys direct. That being said, i have bought quite a few Savox and i'm very happy with them.

    Sent from my VS996...
  10. Replies
    3
    Views
    99

    Also when you have the servo centered the arm...

    Also when you have the servo centered the arm should be a notch or two to the right (as you're looking at it). It shows this in one of the Traxxas manuals. The LCG's can be a pain to get this right,...
  11. Thrre are other companies offer their own version...

    Thrre are other companies offer their own version of TSM. You could sell your TSM system to offset the cost of a AVC system for your Spectrum radio if it is compatable with your transmitter. Their...
  12. Replies
    13
    Views
    487

    Will it hold up if using something like the FLM...

    Will it hold up if using something like the FLM aluminum diff cup? I have a couple 4x4's using the Traxxas stock plastic center diff with 3s batteries but haven't had any issues, but then i probably...
  13. Replies
    29
    Views
    954

    The issue is the different offsets from front to...

    The issue is the different offsets from front to rear, a lot of companys make a 12mm hex wheel that will work on the rear (and 4x4s) but not on the front. The way around that is use the RPM offset...
  14. Replies
    5
    Views
    230

    Spare glow plugs, air filter foams and after run...

    Spare glow plugs, air filter foams and after run oil. I like the rechargable receiver pack too instead of the stock battery pack. The one way bearing and a spur gear or two might be good to have on...
  15. Replies
    15
    Views
    385

    I've taken hits like that and bent the stub axle...

    I've taken hits like that and bent the stub axle also (the part of the axle the wheel bolts to).

    Sent from my VS996 using Tapatalk
  16. Brushed motors can last longer if they're cared...

    Brushed motors can last longer if they're cared for by avoiding getting sand, dirt, and water in them. Upgrading to a Traxxas brushless later could cost more than buying a brushless model now. Or...
  17. Replies
    29
    Views
    954

    In my opinion Primes would not be a good choice...

    In my opinion Primes would not be a good choice for pavement unless it's a immaculately clean surface. They're really good for hard packed clay. I have street fighters front and rear on a lot of...
  18. Replies
    5
    Views
    483

    The tires were probably not glued properly to the...

    The tires were probably not glued properly to the wheels.

    Sent from my VS996 using Tapatalk
  19. Replies
    4
    Views
    1,063

    I prefer lipos 5000mah or higher and 50c or...

    I prefer lipos 5000mah or higher and 50c or higher. The only problem is getting them with the connectors (Traxxas ID style) to fit your new truck.

    Sent from my VS996 using Tapatalk
  20. Replies
    0
    Views
    232

    Pro-line trans

    I have several of these, some i've had trouble with the Pro-line axles (not the Pro-spline type) falling out of the drive cup end on the left side. Is this because of the 4x4 bearing carriers I use...
  21. By the way I do have a couple of the Tazer Twin...

    By the way I do have a couple of the Tazer Twin systems and a couple of their 60a systems, all have worked well for me.

    Sent from my VS996 using Tapatalk
  22. Personally I have seen quite a few times with...

    Personally I have seen quite a few times with different brands the instructions for esc's do not always work exactly the way they say. I think revisions are made on the esc's but the instructions...
  23. Thread: or Maxx

    by dgechrgr469
    Replies
    0
    Views
    444

    or Maxx

    Sorry, but this vs that threads not allowed.
  24. Replies
    18
    Views
    1,200

    They legally can't be sent by air, ground only. ...

    They legally can't be sent by air, ground only.

    Sent from my VS996 using Tapatalk
  25. Replies
    1
    Views
    1,188

    I'm thinking my charger might have a poor...

    I'm thinking my charger might have a poor connection. It started showing a bad cell in more batteries, 2S and 3S. I fiddled with it a bit and it started reading the cell voltage correctly. I do...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4