Search:

Great thanks!

Thanks for the note. It is pretty simple they will not fit they are so tight. As mentioned the nut drivers fit perfectly.

Hi Guys,

looks like Traxxas has obsoleted the body for the previous gen. We have one old one and two ERevo 2.0's. Old one still going like champ. Any suggestions for a replacement body?

Thanks....

Hi Guys,

recently purchased the Traxxas tool kit. Has anyone had a problem with the hex drivers fitting into the driver handle? The nut drivers fit perfect but the hex drivers are tight to the...

If you think the adapters are too resistive then when this happens they should probably be physically hot to the touch. This would indicate the connection has high resistance.

That's the problem. For now I put some Gorilla tape over the gap in the chassis just below the spur gear. Will have my son run it over the weekend then will take a look to see if it helped.

Hey guys.

Looking for some suggestions. We have both the old ERevo and the new one here. My son was running his EREvo 2.0 last weekend and within the space of an hour or so had broken both rear...

Thanks guys. I have some set up tools to allow proper adjustment so will be working on it this weekend. Cheers!

Hey guys.

I recently noticed that for some reason there was visible toe out in the rear of the truck. Upon inspection two things were evident. One axle carrier was damaged, steel insert, and thus...

Nice one!!

That's real nice. I have ordered up the stuff to give it a try. Thanks for the note and pic!

Thanks! I have several torn up bodies and will give this a try for sure.

Hey Guys.

Have a Stampede as part of the collection - 4*4 with Castle Mamba upgrade and various other hop up parts. Looking for suggestions to reduce the damage to the rear of the body - around...

Thanks a lot!!!

Hey guys,

I have a MERV that is being built up witha bunch of hop ups. One is a Castle 4600Kv motor and ESC. I just built another one with a 7700Kv Castle motor and it just screams on 2S!! WIth...

I know this has been posted a few times but wanted to share what I just ran into. So I have two MERVs and one I have been building with a few hops ups - Castle 7700kv motor etc. Before upgrading I...

Looking good - might want to check out some of the higher spec, torque wise that is, from Hitec or Savox - the one you mention is probably less than the two stock Traxxas ones.

Check out VG Racing. Their springs are pretty stiff. If adding the T-Bone stuff you will need stiffer springs for sure. Also with the RPM stuff make sure nothing is over tightened - the car...

Thanks guys!!

I will try a glitch buster - basically a large capacitor. All linkages appear to be smooth with no restrictions noticed. I have reset the end points and everything else that can be...

Hi Guys.

I have a couple of MERVs and decided to hop one up. Lots of Aluminum parts, Savox servo etc. I put some dirt hawg tires on and at some point felt my steering response was slow. Everything...

The wire is a coax cable as stated above. If you have enough wire left you can strip the outer part of the coax cable removing 31.25mm exactly - leaving the inner conductor and its insulation...

I have triplet, almost 8 year old boys! I started them all out with Teton trucks and after 6 months I bought them a Rustler, Bandit and MERV. The time with the Teton truck was worth it and they can...

Ah yes!! I was confused!! Thanks @Squeegie....

@Dacaur.

Thanks! Yes - noted on the reversal process, had to do that with the Savox anyway. My question is if you have two servos one has to be reversed from the other - I do not see how this can...

@dacaur I have the Savox and with the bigger tires I have it seems to struggle some...