Search:

Type: Posts; User: TTegu

Page 1 of 2 1 2

Search: Search took 0.02 seconds.

  1. Thread: steering problem

    by TTegu
    Replies
    2
    Views
    166

    check the manual, I am sure they have it online,...

    check the manual, I am sure they have it online, you just need to reverse that channel. I dont remember how but you use the buttons and access the menu.
  2. Replies
    12
    Views
    771

    I ran mine pretty hard before going brushless,...

    I ran mine pretty hard before going brushless, and my sons has not burnt up yet. While I think they will burn up, sounds to me like something is amiss. I would check the bearings and maybe start...
  3. Replies
    13
    Views
    297

    I run 18 58 for speed runs and 13 58 for bashing....

    I run 18 58 for speed runs and 13 58 for bashing. 18 58 is to high for high grass bashing I would say 16 57 is on the edge for bashing, so I would go a bit lower, but the only way to really tell is...
  4. Replies
    12
    Views
    771

    What size gears are you running? How tight is...

    What size gears are you running? How tight is your slipper? Be sure to check the transmission and wheels for any binding. You will want to check the bearings in the tranny and maybe replace your...
  5. Replies
    36
    Views
    407

    Been wanting to check out that Katy RC. Shoot me...

    Been wanting to check out that Katy RC. Shoot me a PM next time you head that way, maybe we can meet up.
  6. Replies
    36
    Views
    407

    I am right off I-10 probably 1:45 from Bay City...

    I am right off I-10 probably 1:45 from Bay City probably 3 hours from Seagoville. I have 15 acres and I keep saying I am going to rent a bobcat and make a little bashing track.....maybe I will and we...
  7. Replies
    32
    Views
    400

    Check your slipper clutch, might need tightening

    Check your slipper clutch, might need tightening
  8. Replies
    19
    Views
    548

    I run a 3s 5000 mah 40c. My tranny isnt all...

    I run a 3s 5000 mah 40c. My tranny isnt all aluminum but it has a heat sink and even with the motor fan it still gets hot with this set up.....

    ...
  9. Replies
    19
    Views
    548

    I run 3s geared 18 58 32p and I can hit 60 with...

    I run 3s geared 18 58 32p and I can hit 60 with my VXL, but the motor gets hot....I have a fan on the motor and esc and an aluminium transmission....
  10. Size or want a 4x4? I find myself driving the...

    Size or want a 4x4?

    I find myself driving the pede more than the t maxx by far. I am thinking about selling my t maxx and getting a 4x4 pede or a revo. Unless you just want big I would suggest the...
  11. Thread: gearing question

    by TTegu
    Replies
    5
    Views
    171

    Thats a 4.10 I would say its OK, Over 4 for...

    Thats a 4.10 I would say its OK, Over 4 for bashing on a titan should be OK, but you should still watch it to be sure that is as far as I would go, probably on the edge. Its going to die...
  12. Replies
    20
    Views
    254

    To snowfighters point I bought a used xl5 for my...

    To snowfighters point I bought a used xl5 for my son, from him, and he mentioned there might be a problem with the esc or the rx/tx. When i got it the light on the esc did not go off as normal when I...
  13. Replies
    20
    Views
    254

    So when you pull the trigger the esc light turns...

    So when you pull the trigger the esc light turns off like it usuually does? If so, I think you may need to get inside the esc and check the motor connections, since you are sure the motor is good and...
  14. Replies
    20
    Views
    254

    Sounds to me like LVD is on, what color is/was...

    Sounds to me like LVD is on, what color is/was the light when running, what is the light on the esc doing now? Make sure the low voltage detection is off if you are running NIMH.
  15. Replies
    4
    Views
    1,616

    Could be the motor, is it an xl5? Did you check...

    Could be the motor, is it an xl5? Did you check the hexes are they stripped? If it is new Traxxas should help you under warranty.

    Really need more details....
  16. Thread: ESC green to red

    by TTegu
    Replies
    4
    Views
    170

    Yep, you need to turn off the low voltage...

    Yep, you need to turn off the low voltage detection.

    The light should be red when you turn it on. If I recall you need to turn it on then release it. Then hold it again until the light turns red....
  17. Thread: ESC green to red

    by TTegu
    Replies
    4
    Views
    170

    Sounds to me like it is hitting the low voltage...

    Sounds to me like it is hitting the low voltage cut off, are you running Lipo or Nimh. Seems like I threw a Nimh in and left my LCD on and it got a few feet then went red and stopped.
  18. Thread: Which lipo?

    by TTegu
    Replies
    7
    Views
    226

    I went SPC for 2s, the 25c 5000, and Gens Ace for...

    I went SPC for 2s, the 25c 5000, and Gens Ace for 3s, the 40c 5000, and so far I am happy with both of them and would recommend either. Both came balanced, and keep their balance well during...
  19. Thread: Need help ASAP

    by TTegu
    Replies
    18
    Views
    247

    I would guess it is the gear mesh, might want to...

    I would guess it is the gear mesh, might want to loosen the motor and reseat the gears together, not too tight though...
  20. Replies
    0
    Views
    424

    WTB Stampede/Rustler VXL wheels

    ISO some used, but in good condition wheels for a Stampede. Prefer the black chrome, but regular chrome is OK also. Dont need tires just wheels. I figure with everybody upgrading someone may have...
  21. Replies
    7
    Views
    889

    My T-Maxx shell doesnt fit on my stampede so I...

    My T-Maxx shell doesnt fit on my stampede so I doubt the Emaxx would without modification
  22. Thread: Best body pins??

    by TTegu
    Replies
    10
    Views
    1,559

    I use the black ones from HPI, they are a bit...

    I use the black ones from HPI, they are a bit larger than the Stampede clips and stay on fairly well. I rarely loose one.
  23. Replies
    0
    Views
    592

    Snowfighter - Great Seller

    Got the item, it was shipped quick and was as described. Great Seller
  24. Thread: SirSlash4x4 A+

    by TTegu
    Replies
    0
    Views
    674

    SirSlash4x4 A+

    Couldn't get much better, quick ship, easy to deal with.
  25. Replies
    10
    Views
    265

    LOL Nice

    LOL


    Nice
Results 1 to 25 of 35
Page 1 of 2 1 2