Search:

Type: Posts; User: kruqnut

Search: Search took 0.02 seconds.

  1. Replies
    265
    Views
    133,476

    I wish someone could figure out how to seperate...

    I wish someone could figure out how to seperate channels 4 and 5. mine is kinda boned for this trx-4 i bought, i put 2 switches in for 4 and 5, one to tsw up, and one to tsw down, but now i can only...
  2. its the whole setup that the slop is in, i have...

    its the whole setup that the slop is in, i have to constantly retighten the pillow balls via the carrier, and the hex adapters as well.
  3. I thought about sending in for the MM2, but both...

    I thought about sending in for the MM2, but both the mm and MM2 are sensorless only. That was my reasoning behind the Xerun as it goes both ways. The MM i have i can see the damage and its just a...
  4. Replies
    7
    Views
    893

    I've had a revo for about 4 years, I tighten my...

    I've had a revo for about 4 years, I tighten my slipper pretty tight. the motor is far too powerful to expect any type of slipper clutch to stand up long if much slip is allowed.

    on 6s just use...
  5. My ERBE... current status, open for suggestion.

    Hi everyone!

    I've had my ERBE for a couple years now but its been out of commision for about a year since i hit a rock and tumbled into lake huron and fried the esc.

    But im working over the...
Results 1 to 5 of 5