Search:

Type: Posts; User: dgechrgr469

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Best advice so far. i would also recommend...

    Best advice so far. i would also recommend trimming off the part of the rear of the body where it drops down by the bumper. The air dam on the front is also good advice. I left the part of the front...
  2. I don't see why you couldn't use a single post...

    I don't see why you couldn't use a single post other than all the stress on the body during a rollover or crash would be transmitted to a single mounting point instead of spread out over two post. I...
  3. Replies
    1
    Views
    124

    Did you try anything else in the same outlet? ...

    Did you try anything else in the same outlet?

    Sent from my VS996 using Tapatalk
  4. Replies
    13
    Views
    482

    The esc shorted internally because of me...

    The esc shorted internally because of me accidently leaving the battery connected. Connected the new battery and let the smoke out. Nothing wrong with the wiring Connected a new 1/8 Hobbywing no...
  5. Replies
    6
    Views
    201

    I prefer the LCG because of the smooth bottom of...

    I prefer the LCG because of the smooth bottom of the chassis pan and the better handling.

    Sent from my VS996 using Tapatalk
  6. Losi 22SCT shocks are expensive new, if you can...

    Losi 22SCT shocks are expensive new, if you can find some used i would go that route otherwise GTR's or i would recommend Pro-Line Powerstrokes.

    Sent from my VS996 using Tapatalk
  7. Replies
    13
    Views
    482

    Cross your fingers and hope the ESC doesn't smoke...

    Cross your fingers and hope the ESC doesn't smoke when you put the new battery in. Happened to me with a Castle Monster.

    Sent from my VS996 using Tapatalk
  8. The trans cases with the separate suspension...

    The trans cases with the separate suspension mounting points seem to prevent cracking the trans cases like the stock trans. The RPM gearbox takes all the stock trans internals. Pro-Line has their...
  9. I've seen repairs made like you described by...

    I've seen repairs made like you described by using a long screw through the plate and into the post. Try as long of a screw as possible.

    Sent from my VS996 using Tapatalk
  10. Replies
    5
    Views
    351

    Traxxas has a radio guide on their site. It...

    Traxxas has a radio guide on their site. It should tell you what TX you'll need for your RX so you'll need to find the four digit RX # on the label for it.

    Sent from my VS996 using Tapatalk
  11. I have used the Flex Seal tape, it conforms to...

    I have used the Flex Seal tape, it conforms to weird shapes and is very tough. I used it to reinforce cracked bodies and to protect the paint finish on the inside of the body from tire and nerf bar...
  12. Replies
    7
    Views
    373

    I think it would work but i'd make another hole...

    I think it would work but i'd make another hole to "vent" that you could plug after filling to prevent from grease/air being forced out of anywhere it could.

    Sent from my VS996 using Tapatalk
  13. Replies
    3
    Views
    222

    The Slayer shock bodies are roughly 3/10 shorter...

    The Slayer shock bodies are roughly 3/10 shorter than rear Slash shocks. Front slash shocks are slightly shorter than Slayer shocks. I'm not sure if the shock rods are a different diameter between...
  14. Replies
    3
    Views
    222

    I would say the shock bodies would be shorter too...

    I would say the shock bodies would be shorter too so I think all new shocks are in order. I have both at home so if no one else knows I can check mine later.

    Sent from my VS996 using Tapatalk
  15. Replies
    3
    Views
    181

    Hobbywing, Skyrc, Goolrc, Dynamite i've used that...

    Hobbywing, Skyrc, Goolrc, Dynamite i've used that are less expensive than Tekin, Castle etc which i've also used.

    Sent from my VS996 using Tapatalk
  16. Whatever car/truck you have please post it in the...

    Whatever car/truck you have please post it in the correct forum and you should get plenty of responses.

    Sent from my VS996 using Tapatalk
  17. Replies
    3
    Views
    181

    There are several online retailers that sell good...

    There are several online retailers that sell good bramds of esc/motor combos. I could mention brands but you'll always get someone who had a bad experience with it. Make sure you get a esc/motor...
  18. Replies
    11
    Views
    489

    A lot of hobby shops are limited to what their...

    A lot of hobby shops are limited to what their distributor sells, any retailer rarely buys direct. That being said, i have bought quite a few Savox and i'm very happy with them.

    Sent from my VS996...
  19. Replies
    3
    Views
    164

    Also when you have the servo centered the arm...

    Also when you have the servo centered the arm should be a notch or two to the right (as you're looking at it). It shows this in one of the Traxxas manuals. The LCG's can be a pain to get this right,...
  20. Replies
    14
    Views
    1,054

    Thrre are other companies offer their own version...

    Thrre are other companies offer their own version of TSM. You could sell your TSM system to offset the cost of a AVC system for your Spectrum radio if it is compatable with your transmitter. Their...
  21. Replies
    13
    Views
    605

    Will it hold up if using something like the FLM...

    Will it hold up if using something like the FLM aluminum diff cup? I have a couple 4x4's using the Traxxas stock plastic center diff with 3s batteries but haven't had any issues, but then i probably...
  22. Replies
    29
    Views
    1,243

    The issue is the different offsets from front to...

    The issue is the different offsets from front to rear, a lot of companys make a 12mm hex wheel that will work on the rear (and 4x4s) but not on the front. The way around that is use the RPM offset...
  23. Replies
    5
    Views
    283

    Spare glow plugs, air filter foams and after run...

    Spare glow plugs, air filter foams and after run oil. I like the rechargable receiver pack too instead of the stock battery pack. The one way bearing and a spur gear or two might be good to have on...
  24. Replies
    15
    Views
    513

    I've taken hits like that and bent the stub axle...

    I've taken hits like that and bent the stub axle also (the part of the axle the wheel bolts to).

    Sent from my VS996 using Tapatalk
  25. Brushed motors can last longer if they're cared...

    Brushed motors can last longer if they're cared for by avoiding getting sand, dirt, and water in them. Upgrading to a Traxxas brushless later could cost more than buying a brushless model now. Or...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4