Search:

Type: Posts; User: MCF50

Search: Search took 0.01 seconds.

  1. Thread: Traxxas Hoss 4x4

    by MCF50
    Replies
    51
    Views
    6,048

    I don't get it....at that price point just get a...

    I don't get it....at that price point just get a Maxx....and looks like same suspension weaknesses as the Maxx. Noticed on the Traxxas website video they don't show hardly any landings...probalby...
  2. Replies
    4
    Views
    482

    One more comment...at slow to moderate speed...

    One more comment...at slow to moderate speed truck holds straight line. The pulling starts at higher speeds. Any thoughts? I checked bellcranks and servo and they all appear tight.
  3. Replies
    4
    Views
    482

    Thanks. Yes I did adjust trim with TSM off...

    Thanks. Yes I did adjust trim with TSM off (which why they put TSM on these trucks is beyond me....just another sales gimmick). I think the servo saver is a bit worn. The ESC is a loose, but the...
  4. Replies
    1
    Views
    2,033

    Motor to run 2S Lip

    Have a pre-runner and need to replace the spur gear. I have a 2S batt and as we know it burns up motor. Is there a direct swap to allow to run 2S without burning up motor or is this just going to...
  5. Replies
    4
    Views
    482

    Maxx - Steering Drift after crash

    So I was doing a 4S speed run on my street...at about 40mph and lost it...barrel roll down street. Only thing that happened was the right front wheel steel driveshaft popped out of cup. Took front...
  6. Replies
    1
    Views
    622

    Think I got the right set up for me..

    Think I finally found a good setup for the way I play...just driving thru front yards, across driveways and up and down street with speed runs. Jumps are no more than 'bumps' or slight dips between...
  7. Thanks. Does the TMAXX suffer the same chassis...

    Thanks. Does the TMAXX suffer the same chassis slap issues as the Maxx?
  8. X-Maxx Purchase - Must have 'upgrades' (ie things that should have been included)

    With an Xmaxx other than two 4S batts and chargers, what other 'must get day 1' "accessories" (upgraded servo, bearings, cups, shafts, etc. etc.) are required. I'm talking about things people have...
  9. Replies
    3
    Views
    958

    Stock rear widemaxx springs are 1.725. With the...

    Stock rear widemaxx springs are 1.725. With the rear weight distribution a 2.0 spring rate would be much much better.
  10. Widening Stance without WideMaxx - Wheel Spacers

    I have the Widemaxx Kit and as much as I like the handling (almost impossible to roll) the low clearance bugs me. Thinking of going back to stock arms. Before I put the Widemaxx kit on I did try...
  11. Replies
    8
    Views
    1,216

    WideMaxx Chassis Slap

    I have the Widemaxx with steel drivshafts. Put in 100wt oil in the rear and 70wt in the front. Getting plenty of chassis slap off small jumps and just transitioning from the street up driveways at...
Results 1 to 11 of 11