Search:

Type: Posts; User: Rain Dawg

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Thread: RX voltage.

    by Rain Dawg
    Replies
    2
    Views
    55

    Some on here seem to get away with it but not me,...

    Some on here seem to get away with it but not me, I fried 2 above the 6v so now I've learned my lesson and use a CC bec if I need higher volts because I don't want to switch out rx & tx's.

    It's a...
  2. Replies
    13
    Views
    160

    They make alot of different versions of these but...

    They make alot of different versions of these but here's a couple of ideas.
    https://www.youtube.com/watch?v=bQ4wUHCWasY&t=3s...
  3. If you have the Castle link you can set the low...

    If you have the Castle link you can set the low voltage cutoff and maybe update the firmware in the esc. If you don't have the link check with a friend or see if your lhs has one or can put you in...
  4. Not sure what to tell you, I've never had it...

    Not sure what to tell you, I've never had it happen but the only thing that comes to mind is maybe when you tipped it over, water ran into the battery connection and maybe a fail safe shut it off...
  5. Try adding the M41 and see what it does.

    Try adding the M41 and see what it does.
  6. Try adding a second Spartan in the select a model...

    Try adding a second Spartan in the select a model and put a hash tag and a number 1 beside it and then make it active, then go into the garage and see if it will allow you to set it up, if so then...
  7. Thread: ESC coolers

    by Rain Dawg
    Replies
    37
    Views
    2,826

    I thought about one of these too, but my temps...

    I thought about one of these too, but my temps haven't required one yet, but maybe one day just to try it.

    https://www.youtube.com/watch?v=bQ4wUHCWasY
  8. I pull my rubber grommet when my shaft is out...

    I pull my rubber grommet when my shaft is out about every 5 runs and put Green Slime (or marine grease) on it evertime and mine has never leaked since. My bet is you do the same and your good to go.
  9. Clear as mud sort of lol. I recall another thread...

    Clear as mud sort of lol. I recall another thread you had or in another post don't recall which, you had used airplane cable (again I think) to up size your cable diameter. Is this still the same...
  10. Thread: ESC coolers

    by Rain Dawg
    Replies
    37
    Views
    2,826

    Looks good, mine works so I'm confident yours...

    Looks good, mine works so I'm confident yours will lower temps also.
  11. Replies
    10
    Views
    149

    Check that the battery wires are still attached...

    Check that the battery wires are still attached with solder properly in the connector's and check the plug for the esc in the rx it might be loose. It could be faulty wires on the battery itself like...
  12. If your referring to the large plug opening...

    If your referring to the large plug opening beside the TSM logo on the rx it's for the Telemetry expander for adding more sensors. The after market esc just plugs into the third slot like a normal...
  13. Replies
    5
    Views
    123

    You should do as Double G stated and check the...

    You should do as Double G stated and check the cells voltage. I would not want to be responsible if I was you if you just threw them out and something happened, so check SMC'S website for proper...
  14. Mine work great with Castles MM2 and their 2200kv...

    Mine work great with Castles MM2 and their 2200kv and a second one with a Skyrc combo but can't speak for others but don't see why not.
  15. Replies
    4
    Views
    106

    Make sure when you solder any of the xt's you put...

    Make sure when you solder any of the xt's you put the male and female together to keep them from deforming and use a good heat source for minimal amount of time on the connector. I use a Hako...
  16. Replies
    11
    Views
    294

    I'm assuming the plug gave it power from the esc,...

    I'm assuming the plug gave it power from the esc, so you might need to get a bec to step the voltage down to what the lights were rated for, unless your batteries are ok at the volts it lists to hook...
  17. You and me both lol.

    You and me both lol.
  18. Replies
    4
    Views
    106

    The xt-60's will be fine, that's all I use on my...

    The xt-60's will be fine, that's all I use on my 2s and xt-90's on 3s. 10 gauge would be better with 3s and up otherwise you'll be fine.
  19. Replies
    4
    Views
    81

    Not sure if the Mod's allow it so just look up...

    Not sure if the Mod's allow it so just look up gens ace 3s 45c 5300 mah, I just found these cheaper at my LHS that is now closed, then I could get of other manufacturers.
    If you live in the U.S.A....
  20. Replies
    4
    Views
    81

    I would not go below 5000 mah 45c. I run 2-3s...

    I would not go below 5000 mah 45c. I run 2-3s 5300 mah 45c gen's ace right now and have not had any performance issues whatsoever. I avg. about 15 to 20 min. of run time depending on the driving and...
  21. Replies
    2
    Views
    79

    I doubt your missing anything, it's probably just...

    I doubt your missing anything, it's probably just a weak servo.

    I ran the 2 - 2075x servos for a couple of years in our BL Emaxx before I had issues, but mine boiled down to the big tires I was...
  22. Did yours come with the motor temp sensor...

    Did yours come with the motor temp sensor installed in the heat sink, if so it might be damaged and should be checked. This has been known to cause power loss.
  23. Replies
    227
    Views
    5,976

    Thank you very much.

    Thank you very much.
  24. Thread: ESC coolers

    by Rain Dawg
    Replies
    37
    Views
    2,826

    Yes that would be the most effeicent way lol....

    Yes that would be the most effeicent way lol. After I had soldered the round one in the middle I realised it would have been easier to just solder the round ones into place. Good catch, and yes if...
  25. Replies
    227
    Views
    5,976

    Are these a direct purchase from Promodeler? I...

    Are these a direct purchase from Promodeler? I can't seem to find them for sale anywhere else.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4