Search:

Type: Posts; User: CrazyXMAXX

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    9
    Views
    148

    Not worthy in my book R&D proves Stock wheelie...

    Not worthy in my book

    R&D proves Stock wheelie bar for the win
    Go Traxxas
  2. Using a 18t pinion without the pins under the ...

    Using a 18t pinion without the pins under the
    motor mounts is recommended -
    setting the mesh by hand with just a little play

    Noise turning by hand seems normal
    debris cleaned out of cavities...
  3. Replies
    3
    Views
    133

    Expected from him

    Expected from him
  4. Remove the diff cover - inspect parts Possibly...

    Remove the diff cover - inspect parts
    Possibly part #8982 has failed
    or #8950 in the manual
  5. Replies
    3
    Views
    207

    Remove the center cover and spin the wheels If...

    Remove the center cover and spin the wheels
    If the center shaft is bent - replace
  6. Replies
    1,808
    Views
    304,357

    Had the front bearing fail for the center...

    Had the front bearing fail for the center spool/diff on the the original 6s Xmaxx
    4 year old bearing finally spewed it’s balls- it had been cleaned and lube a few times, but then neglected
    -...
  7. Thread: Bad ESC?

    by CrazyXMAXX
    Replies
    34
    Views
    557

    Have you adjusted the throttle sensitivity to 0%

    Have you adjusted the throttle sensitivity to 0%
  8. Replies
    5
    Views
    187

    Supply line might be interrupted during these...

    Supply line might be interrupted during these pandemic times
  9. Thread: Batteries

    by CrazyXMAXX
    Replies
    5
    Views
    329

    Yes an adapter would work Best to solder on...

    Yes an adapter would work
    Best to solder on traxxas connector though
    After the 30 warranty- change esc plug to ec5 plug on Maxx
  10. Replies
    4
    Views
    169

    Center drive shaft needs replacing Body in...

    Center drive shaft needs replacing

    Body in the side guards

    Body cracks repaired with e6000 / goop
  11. Replies
    5
    Views
    120

    Looks normal for stock parts No worries - just...

    Looks normal for stock parts
    No worries - just thrash it
  12. Replies
    5
    Views
    120

    Take a video/ post here Email to Traxxas...

    Take a video/ post here
    Email to Traxxas support

    Some play is normal
  13. Replies
    7
    Views
    362

    New or used Xmaxx’s is the ticket All are...

    New or used Xmaxx’s is the ticket
    All are worthy
    Get a few sets of 5000mah or more
    50C or more traxxas plug ,4s lipo
    You’ll be very happy with an Xmaxx
  14. Yeah If it had no lights when turning on- then...

    Yeah
    If it had no lights when turning on- then the receiver smoked
    The esc is most likely done
    Usually the esc will flash all red lights when defective tho

    Jennysrc on eBay for a new receiver...
  15. Could be Try a different esc an a different...

    Could be
    Try a different esc an a different receiver
    If you try just a new receiver the esc might smoke it

    Hobby Wing max6 esc for the win
  16. Replies
    26
    Views
    608

    The 6s clutch adjustment needs to be tightened...

    The 6s clutch adjustment needs to be
    tightened and double nuts to lock it

    8s upgrade fix;
    7786X 8s input shaft transmission (cush drive)
    7794 Cush drive key/ pin/elastomer damper
    7793X...
  17. Replies
    15
    Views
    361

    This is a common problem Sometimes it can...

    This is a common problem

    Sometimes it can take a few times to really stick on there
    Each time it happens heat it an run the set screw through before loctite again
  18. Replies
    1
    Views
    114

    Ask the manufacturer Post a link to product ...

    Ask the manufacturer

    Post a link to product

    Heavier wheels tires not recommended with stock axles = failure
  19. Replies
    13
    Views
    231

    Email this response with pictures of the sales...

    Email this response with pictures of the sales receipt and stripped gears to Traxxas support.com
    Tech musta been having a bad day

    2087x is worthy = repair and go

    Bash On and Good Luck
  20. Recalibrate Try a different esc Slow is not...

    Recalibrate
    Try a different esc

    Slow is not as fun :thumbdown:
  21. Have you installed the latest updates ? Check...

    Have you installed the latest updates ?
    Check throttle sensitivity settings - 0% for punch
  22. If it will turn over an everything working...

    If it will turn over
    an everything working freely
    Should run like it did
  23. Thread: Bad ESC?

    by CrazyXMAXX
    Replies
    34
    Views
    557

    Got rid of the center diff on my 8s Xmaxx years...

    Got rid of the center diff on my 8s Xmaxx years ago
    Installed the Hot Racing center spool XMX51PE
    No more rebuilding the unwanted center diff

    Do it well brothers
  24. Original tools should complete it with a Thin...

    Original tools should complete it with
    a Thin walled 17mm socket for new axle nut
  25. Replies
    13
    Views
    231

    Support will send you a replacement plastic servo...

    Support will send you a replacement plastic servo gear set
    2087X is the metal gear set
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4