Search:

Type: Posts; User: Panamon Creel

Page 1 of 18 1 2 3 4

Search: Search took 0.02 seconds.

  1. Gracias, I already have the manual and I even...

    Gracias,
    I already have the manual and I even checked the manuals in the three different languages I'm familiar with and they all say on page 13 that it should just be switch on and go with...
  2. Using different TQI (blue) transmitters with the same receiver.

    Trying to use two different TQI blue transmitters ( one 4 and one 2 channel, the former with the BT link module installed) with the same TQI receiver, which according the manual should be possible. ...
  3. Replies
    2
    Views
    3,050

    Storage mode will discharge down to storage...

    Storage mode will discharge down to storage voltage or charge up to storage voltage. Discharging down to storage level can take a very long time with higher capacity batteries since the EZ Peak Live...
  4. Replies
    7
    Views
    2,678

    The adapter you linked in your OP will work with...

    The adapter you linked in your OP will work with both ID and the older non ID NiMH batteries however charging ID LiPo will be more difficult since ID LiPo batteries do not have a separate balance...
  5. Replies
    5
    Views
    832

    Rechargeable Lithium Ion batteries, unlike...

    Rechargeable Lithium Ion batteries, unlike primary Lithium cells, actually contain none to very little metallic Lithium so using Water in conjunction with a Lithium Ion battery thermal run-away will...
  6. Replies
    7
    Views
    1,080

    Fine tuning of the indicated vs. actual speed can...

    Fine tuning of the indicated vs. actual speed can be done via the drive ratio value in the app. However just one short spin of your tires can cause a huge difference between the Link Max. speed and...
  7. Battery Traxxas ID connectors are compatible with...

    Battery Traxxas ID connectors are compatible with the non ID plug on older models.

    Charging of NiMH with ID connectors on a charger with non ID connector also is not a problem and does not require...
  8. Replies
    1
    Views
    455

    1st generation TQi transmitters ( red TQi symbol)...

    1st generation TQi transmitters ( red TQi symbol) work with the docking base, 2nd generation TQi transmitters (Blue TQi symbol) only work with the link module.
  9. You should stop when you notice poor...

    You should stop when you notice poor acceleration, pushing it beyond will result in the battery heating up significantly and heat is poison to the battery pack. No need to worry about memory effect....
  10. Replies
    5
    Views
    1,432

    As ksb51rl mentioned above, the EZ peak Dual has...

    As ksb51rl mentioned above, the EZ peak Dual has a very low discharge amperage so bringing a fully charged battery down to storage level will take a long time. Better/faster to charge up to storage...
  11. Replies
    5
    Views
    1,432

    what's the capacity of the batteries you've...

    what's the capacity of the batteries you've connected?
    I'm assuming you've fully charged batteries connected and trying to discharge them to storage voltage, is that correct?
  12. It is for fire safety in the rare event that the...

    It is for fire safety in the rare event that the battery has an internal short due to a manufacturing defect or damage received during prior use or charging that was not immediately apparent when the...
  13. Replies
    7
    Views
    723

    The TQI system usually has a pretty good range so...

    The TQI system usually has a pretty good range so you should look into interference and/or antenna issues on the receiver end. Check that the receiver antenna cable is not pinched/damaged and that...
  14. Replies
    20
    Views
    4,337

    You'll likely have more wear of the plating on...

    You'll likely have more wear of the plating on the whole blade contact surface from the friction on each connect/disconnect cycle than you get from the arcing on the tip of the blades on connect with...
  15. Replies
    20
    Views
    4,337

    The spark doesn't cause problems for the ESC. It...

    The spark doesn't cause problems for the ESC. It might cause minimal wear on the tips of the plugs where the initial contact is made but that's about it.



    Well higher Voltage mean less...
  16. Replies
    2
    Views
    664

    The EZ-Peak dual has a very low max. discharge...

    The EZ-Peak dual has a very low max. discharge current so discharging a high capacity battery from full charge to storage level will take very long. Better/faster to charge up to storage Voltage...
  17. Replies
    12
    Views
    1,931

    The C Rating current is based* of the rated Ah (...

    The C Rating current is based* of the rated Ah ( or mAh ) and not the available charge capacity of the battery. The ESR (Equivialent Series Resistance) will come into play in a partially discharge...
  18. Replies
    12
    Views
    1,931

    I'd rather say the question is what continuous...

    I'd rather say the question is what continuous amperage draw do you actually have, what size of battery (or batteries) will fit and is there a weight limit for the batteries?
    i.e. a 10000mah 25C...
  19. Replies
    20
    Views
    4,337

    Double or triple it, still won't be a problem...

    Double or triple it, still won't be a problem with the little spark you get from the very short charge up load for the ESC capacitors. Now if you'd disconnect the plug under a high load then you...
  20. Replies
    20
    Views
    4,337

    The spike eliminating variable resistors are...

    The spike eliminating variable resistors are generally NTC Thermistors which start out with a high resistance when cold and while connected under load heat up which lowers their resistance until they...
  21. Replies
    20
    Views
    1,287

    How many charge cycles on the batteries in...

    How many charge cycles on the batteries in question (approximately) ?
    Had the batteries in question been in regular use up until now, or had they been in storage prior to that?
  22. Replies
    2
    Views
    502

    The indicator LEDs show the charge level and not...

    The indicator LEDs show the charge level and not the charge current after you start the charge.
  23. Replies
    8
    Views
    1,127

    first take a meter and measure the voltage level...

    first take a meter and measure the voltage level of each cell
  24. yeah thread revival after two and a half years :)...

    yeah thread revival after two and a half years :)

    The mAh the charger puts into the battery depends on how far the battery was discharged before the charging was started.
  25. Replies
    15
    Views
    5,976

    Standard TQi sensors are Voltage, Temp and RPM...

    Standard TQi sensors are Voltage, Temp and RPM (the RPM sensor will also give you a derived Speed calculation in the App).
    The Expander module allows for additional Temperature, Voltage sensors and...
Results 1 to 25 of 450
Page 1 of 18 1 2 3 4