Search:

Type: Posts; User: donnie533

Search: Search took 0.00 seconds.

  1. I am running stock arms, with the RPM rear...

    I am running stock arms, with the RPM rear carriers. I have used the RPM threaded hinge pins on rear upper and lower, as well as front upper and lower. I had to modify the front upper pin to fit...
  2. Replies
    8
    Views
    487

    I would suspect that you need to push the pins...

    I would suspect that you need to push the pins out of the connector on the ESC and install them in this included connector, so that you can tap into the battery.
  3. Thread: Gtr shocks

    by donnie533
    Replies
    4
    Views
    396

    I replaced my Rustler 4x4 vxl shocks with the GTR...

    I replaced my Rustler 4x4 vxl shocks with the GTR shocks (XXL for rear, L for front) and used the shock oil that came with them.
    I was popping the caps off the stock shocks - the GTR are a huge...
  4. Before drilling the head of a screw that is in...

    Before drilling the head of a screw that is in plastic - try using a left handed drill bit. I have found these will bite into the screw head and backout the screw. Worst case is you use it to drill...
  5. Replies
    41
    Views
    2,365

    just added an X-MAXX to my 2 E-Revo 2.0's and...

    just added an X-MAXX to my 2 E-Revo 2.0's and Rustler VXL 4x4

    also have an old MGT 4.6 nitro truck and 2 proboat sonicwake boats
  6. Replies
    22
    Views
    1,479

    my servo failed after just 2 packs of batteries. ...

    my servo failed after just 2 packs of batteries. The servo motor would spin but no steering. Fortunately it happened at very slow speed. Traxxas support was good, they are sending out a...
Results 1 to 6 of 6