Search:

Type: Posts; User: fortunespoonz

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. In the second video you are turning the input...

    In the second video you are turning the input shaft. The video shows the end with the gear and the pin in question.
    That gear is usually pretty tight on the shaft and will stick and turn the trans...
  2. I’m trying the alum. pads on my stock clutch. I...

    I’m trying the alum. pads on my stock clutch. I assume they’ll last longer.
    Not usually a problem for me but you may want to upgrade the whole thing if your racing hard.
  3. Maybe the roll pin on the input shaft. The gear...

    Maybe the roll pin on the input shaft. The gear is pretty tight on the shaft and itís easy to miss the broken pin.
    Until you try and drive the truck and the shaft just spins in the gear.
  4. Your pads are probably just heat glazed. If not...

    Your pads are probably just heat glazed. If not fouled with oil, they can be renewed with some light sandpaper and circular rubbing. I would also change out the nylock nut in case itís loosening...
  5. The second link is better IMO. I use the...

    The second link is better IMO.

    I use the rustler front mount sometimes on some of my Stampedes.
    ...
  6. Replies
    21
    Views
    493

    I keep used bearings. I use new for comparison...

    I keep used bearings. I use new for comparison for the “wiggle test”.
    From that I get 3 piles, yes, NO and maybe. No’s go in the trash and the others get kept.
    I’ll use the others for wheel...
  7. Replies
    21
    Views
    493

    Replace them all at once. Save yourself extra...

    Replace them all at once. Save yourself extra work every time another fails down the line.
    2 years is a good run. Time to tear it all apart and start fresh and clean.
    If it was me , Iíd get a new...
  8. Also check throttle trim knob, 70/30 switch if...

    Also check throttle trim knob, 70/30 switch if applicable and the antenna wire.
  9. you need to recalibrate the esc to the radio most...

    you need to recalibrate the esc to the radio most likely
  10. Replies
    6
    Views
    263

    Where the rubber meets the road is were the...

    Where the rubber meets the road is were the action happens!
    Good tires are key. With the wider rear, this actually improves steering.
    So it will probably help the push you arenít worried about...
  11. Replies
    3
    Views
    237

    I have some. I personally wouldnít pay retail for...

    I have some. I personally wouldnít pay retail for them. I got mine with used rigs and let others pay the depreciation.
    They are good shocks but not noticeably better on my rigs. Ive got a spring now...
  12. Replies
    8
    Views
    328

    I have the J Concepts over tray. Works great in...

    I have the J Concepts over tray. Works great in the winter. It definitely traps heat all other times of year.
    I have opened up the front to let in air under the hood, so far no crud gets in there....
  13. A narrower front end turns more, so inversely, a...

    A narrower front end turns more, so inversely, a wider front end will turn less.
    That can be a good thing if you are trying to correct oversteer.
    A wider rig is generally more stable.
    The protek...
  14. Replies
    6
    Views
    433

    Buying an inexpensive temperature gun is always a...

    Buying an inexpensive temperature gun is always a good idea to keep an eye on temps.
    Driving style and terrain play a huge role as well in overheating. Grass is hard on the gear...
  15. Replies
    8
    Views
    349

    I stand corrected

    I stand corrected
  16. Replies
    8
    Views
    349

    19/90 is stock gearing. 30/83 is really high,...

    19/90 is stock gearing. 30/83 is really high, unless you have a low kv motor.
    That’s speed run gearing, not good for bashing or sustained use. It will kill a vxl!
    Slash 4x4 rear axles are a nice,...
  17. Replies
    5
    Views
    171

    Check motor/esc wires and all connections

    Check motor/esc wires and all connections
  18. Replies
    20
    Views
    1,234

    Yep. I was hoping you did too. Lots of good info...

    Yep. I was hoping you did too. Lots of good info in the manual...
    I just now googled “switch vxl to lipo” and got the link to the manual...
  19. Replies
    7
    Views
    477

    There’s the linear white springs, 4# rating,...

    There’s the linear white springs, 4# rating, which are stock on Rustlers and Stampedes.
    There’s the progressive white springs, 4# rating I believe, from the Slash.
    There are also red springs, 2.5#...
  20. Replies
    20
    Views
    1,234

    Did you switch the esc to lipo mode? You may be...

    Did you switch the esc to lipo mode? You may be triggering over voltage if still in nimh mode.
  21. Replies
    17
    Views
    578

    Oval racing is out there. Some awesome videos on...

    Oval racing is out there. Some awesome videos on YT of rcs racing on velodromes.
    I wish we could get that going locally for oval racing but not enough commitment.
  22. Replies
    7
    Views
    335

    https://scontent-yyz1-1.xx.fbcdn.net/v/t1.6435-9/1...

    https://scontent-yyz1-1.xx.fbcdn.net/v/t1.6435-9/167325561_10158972654044763_3759377945998804325_n.jpg?_nc_cat=100&ccb=1-3&_nc_sid=dbeb18&_nc_ohc=o7P3qecSWOYAX-ECRUq&_nc_ht=scontent-yyz1-1.xx&oh=876b7...
  23. Maybe the Stampede Grave Digger mounts will work....

    Maybe the Stampede Grave Digger mounts will work. I’ve used the rear before with high bodies.
  24. Replies
    7
    Views
    335

    Well I found a stock diff, stuffed full of...

    Well I found a stock diff, stuffed full of grease, hence the different feel.
    Hopefully that will help the under steer that I have with this chassis.
    That would be ironic, due to extra effort Iíve...
  25. Replies
    17
    Views
    578

    What they said^ I was talking 2wd. lol. On my...

    What they said^
    I was talking 2wd. lol.
    On my 4x4 it was the above mentioned bearing that went and took out my spur.
    And I recall now I put a new spur in it and chewed it right away.
    Then I...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4