Search:

Type: Posts; User: Charger Man

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Did you receive that part I suggested yet? Any...

    Did you receive that part I suggested yet? Any updates?


    Sent from my iPhone using Tapatalk
  2. Replies
    35
    Views
    726

    I would love to get my hands on some of those LEM...

    I would love to get my hands on some of those LEM o-rings but I canít seam to find any online [emoji3525] Where did you get yours and how long ago?


    Sent from my iPhone using Tapatalk
  3. Replies
    35
    Views
    726

    Yup and itís nothing to worry about. Sounds like...

    Yup and itís nothing to worry about. Sounds like your getting really close. Hope it goes well and lasts a while.


    Sent from my iPhone using Tapatalk
  4. Replies
    35
    Views
    726

    Which type of grease to use in a diff?

    The grease from the factory was likely white when it was new. The grease turning blackish grey is normal. Itís from the internal gears wearing ever so slightly. They are black when new and as they...
  5. Replies
    35
    Views
    726

    I use this grease on all of my diffs. ...

    I use this grease on all of my diffs.
    https://shop.advanceautoparts.com/p/lucas-oil-products-x-tra-heavy-duty-grease-145-oz-10301/7070035-P


    Sent from my iPhone using Tapatalk
  6. https://uploads.tapatalk-cdn.com/20190908/d46d4c16...

    https://uploads.tapatalk-cdn.com/20190908/d46d4c16fb12c4089c1e96e2a8a59fc2.jpg


    Sent from my iPhone using Tapatalk
  7. https://uploads.tapatalk-cdn.com/20190908/c2d6e118...

    https://uploads.tapatalk-cdn.com/20190908/c2d6e1182412ff124dbb617f9d7f3281.jpg


    Sent from my iPhone using Tapatalk
  8. Itís a tight fit. Since itís a little longer it...

    Itís a tight fit. Since itís a little longer it has the whole width of the bearing on the adapter. The traxxas one only allows for a portion of the bearing to go on.


    Sent from my iPhone using...
  9. I canít seam to find the post but this was...

    I canít seam to find the post but this was recommended and works great. Just use it in place of the traxxas one. ...
  10. Thread: Receivers

    by Charger Man
    Replies
    1
    Views
    108

    Depends on the part # of the receiver. Traxxas...

    Depends on the part # of the receiver. Traxxas has a compatibility guide here:
    https://traxxas.com/support/Traxxas-TQi-Compatibility-Guide


    Sent from my iPhone using Tapatalk
  11. Replies
    14
    Views
    647

    I always run mine blowing air onto my motor or...

    I always run mine blowing air onto my motor or esc. The fans are much better blowing air rather than pulling hot air away. Example, hold your hand 1Ē from your mouth and suck in as much air as you...
  12. Truck bodies with the quick release system

    You donít have to retrofit anything to make the 1.0 body posts fit on the 2.0. Itís a direct fit allowing you to run any body you want.

    Edit: All you need for the front and rear is part #5314...
  13. I apologize for the long read. How do you like...

    I apologize for the long read.
    How do you like the .21tm? I have a slayer pro 4x4. First nitro Iíve owned. Got it October 2017. Had about 1 gallon through it and something went wrong and wouldnít...
  14. Replies
    8
    Views
    359

    You could install a sway bar kit from hot-racing...

    You could install a sway bar kit from hot-racing on your merv. I put one on mine and it handles a lot better.
    ...
  15. Perhaps the thicker fluid isnít allowing the rear...

    Perhaps the thicker fluid isnít allowing the rear end to absorb the bump fast enough and just ends up popping the rear end up. Usually you will need to keep on the throttle after leaving a jump to...
  16. Replies
    58
    Views
    6,356

    That should be fine for that motor. Perhaps check...

    That should be fine for that motor. Perhaps check if motor rotation is selected to be reversed on the esc. If so, change it to normal and flip any two of the three wires around that go to the motor...
  17. Replies
    58
    Views
    6,356

    What is the motor timing set to. I think 10į is...

    What is the motor timing set to. I think 10į is default. I had improvements running a tpp motor by taking it down to 0į of motor timing.


    Sent from my iPhone using Tapatalk
  18. No, the 2.0 has gold (3.8 rate) front and tan...

    No, the 2.0 has gold (3.8 rate) front and tan (4.1) rear
    https://uploads.tapatalk-cdn.com/20190329/efdd9535bdee05355ebdda091e205852.jpg

    What I have is silver (4.9) front and blue (5.9) rear...
  19. I have used these on my 1.0 for years and now on...

    I have used these on my 1.0 for years and now on my 2.0 ERevo.
    Front:
    https://traxxas.com/products/parts/5442

    Rear:
    https://traxxas.com/products/parts/5444

    Even though they say they are...
  20. Replies
    6
    Views
    551

    Iím about to buy the hot racing shock bodies. I...

    Iím about to buy the hot racing shock bodies. I just have one question. Can you use the stock traxxas rebuild kit for the shocks o-rings? Part#7062 https://traxxas.com/products/parts/7062


    115...
  21. Replies
    2
    Views
    161

    Also I found this within the app under model...

    Also I found this within the app under model setup in the garage. There is a help button at the top and the picture below explains that drive ratio gear 1 number. So if you changed that you may need...
  22. Replies
    2
    Views
    161

    This might help you make calculations easier....

    This might help you make calculations easier. Keep in mind if your using 2s lipoís there are two of them in series combined for a total of 4s.
    https://scriptasylum.com/rc_speed/top_speed.html

    ...
  23. Replies
    8
    Views
    744

    Okay. If you have some practice with soldering...

    Okay. If you have some practice with soldering wires you could wire the fan on the esc straight to the receiver with a servo wire extension. That way as soon as you turn the truck on the esc fan will...
  24. Replies
    8
    Views
    744

    That depends on if you have the factory Traxxas...

    That depends on if you have the factory Traxxas VXL6s esc or an aftermarket esc. I personally donít have any experience with how cool the factory esc runs.


    Sent from my iPhone using Tapatalk
  25. Replies
    8
    Views
    744

    I recommend and run myself the yeah racing dual...

    I recommend and run myself the yeah racing dual fan with aluminum heat sink.
    Available in black https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F272114179295
    And...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4