Search:

Type: Posts; User: grizzly03

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    10
    Views
    121

    I've only experience the vehicle jerking at idle....

    I've only experience the vehicle jerking at idle. I could watch the spur spin up and then something internal would grab for a split second and the truck would jerk and spur would stop spinning. And...
  2. Replies
    3
    Views
    57

    Here is the News on the...

    Here is the News on the update:https://traxxas.com/news/vxl6s-firmware-update



    If it was to make sure you unplug the batteries, why do the buttons work on other Traxxas Esc's.
  3. I would upgrade from the plastic pipe. I never...

    I would upgrade from the plastic pipe. I never had good luck with them. For a cheap metal pipe that would work, you could get a jato pipe from a chop shop.

    If you tip the car sideways toward the...
  4. Replies
    10
    Views
    121

    What do you mean by yours lurches? If you have...

    What do you mean by yours lurches?
    If you have reverse installed, and at idle your truck seems to rock. That can be normal. Lowering the idle helps.
    If you don't have reverse it shouldn't move at...
  5. The best upgrade that I did to fix similar...

    The best upgrade that I did to fix similar breakage I had was to replace the plastic bulkheads with aluminum ones.

    I don't know how you could break a skid plate and chassis brace and not damage...
  6. Replies
    3
    Views
    40

    If you are using a Traxxas charger with Traxxas...

    If you are using a Traxxas charger with Traxxas ID batteries the settings are done automatically. It chooses the settings for you. There is a chip in the ID connector that tells the charger what...
  7. Sounds like you are having a blast! You can...

    Sounds like you are having a blast!
    You can install TSM on the 4-tec. Just need a TSM receiver and a transmitter that works with the TSM receiver.
  8. Except when running in a sensored setup, then it...

    Except when running in a sensored setup, then it uses the sensors inside the motor.

    If your a racer and worrying about things like motor timing, you wouldn't be using adapters in the first place....
  9. Thread: Radio issues

    by grizzly03
    Replies
    6
    Views
    98

    Maybe try braiding the three motor wires,...

    Maybe try braiding the three motor wires, sometimes it helps. Try moving the antenna wire farther away from the ESC and motor.

    If that doesn't help you might need to upgrade to a 2.4Ghz.
  10. You might be able to find an aftermarket body...

    You might be able to find an aftermarket body that fits, they are made out of heavier plastic and hold up better. You would need to compare measurements.
    Look through the picture gallery for ideas.
  11. Thread: Radio issues

    by grizzly03
    Replies
    6
    Views
    98

    How are the antenna's (both transmitter &...

    How are the antenna's (both transmitter & receiver)? Have you tried new batteries in transmitter.
  12. Replies
    6
    Views
    71

    It's sad news indeed. I've had good luck with...

    It's sad news indeed. I've had good luck with their fuels. It's getting harder and harder to keep nitro alive!

    At least I'm glad their employees will still have a job, especially with what is...
  13. Replies
    1
    Views
    55

    On the Traxxas 2.4Ghz receivers you wouldn't need...

    On the Traxxas 2.4Ghz receivers you wouldn't need the y-harness, they have two channel 1 slots.
    CH1 steering servo
    CH1 steering servo
    CH2 esc
  14. Replies
    10
    Views
    121

    It could also be the friction pegs in the spur...

    It could also be the friction pegs in the spur gear. They could be worn down. They should stick out past the spur gear slightly.

    Here is a link of what I'm talking about....
  15. Replies
    14
    Views
    161

    1. At idle on the ground the vehicle shouldn't...

    1. At idle on the ground the vehicle shouldn't move. If you lift the car in the air the wheels will turn.

    2. Here is some help for tuning your engine:...
  16. No need to go to trouble trying to make your own...

    No need to go to trouble trying to make your own wiring. Traxxas sells an adapter that allows you to charge a rechargeable pack (Rx battery) with the same charger for the EZ-start wand battery....
  17. Correct. The TSM function is part of the...

    Correct. The TSM function is part of the Receiver, not part of any ESC/motor.

    Traxxas TSM works on the Nitro vehicles that don't have an ESC or electric motor.
  18. Or you could get adapters to go from 3.5mm male...

    Or you could get adapters to go from 3.5mm male bullet (Traxxas motor wires) to 4mm female bullet connector (Castle ESC connector).
    Here is an example...
  19. I really like the new Erevo 2.0 also! The...

    I really like the new Erevo 2.0 also! The drive-train handles 6s without ripping itself apart vs the V1.

    I'm still enjoying the Nitro's also. You can't beat the sound they make.

    As for your old...
  20. Thread: 28mph on 2s

    by grizzly03
    Replies
    8
    Views
    228

    It's the tires that kill the speed performance. I...

    It's the tires that kill the speed performance. I have both a summit and merv and the summit is a handful at higher speeds.
    But they both are fun!
  21. Replies
    14
    Views
    161

    If you have the Blue Tooth link module and the...

    If you have the Blue Tooth link module and the Traxxas app, adjust the setting in the app.
    Select the model, then go to Drive effects, then move throttle trim to get the required gap.

    If you...
  22. I would like to see a new nitro engine with a new...

    I would like to see a new nitro engine with a new carb. Anywhere between .21 to .23 and I would be super happy.
  23. Replies
    14
    Views
    161

    The carb slide shouldn't move when you apply the...

    The carb slide shouldn't move when you apply the brakes.

    If you haven't adjusted the linkage when you upgraded the radio try adjusting the trim on channel 2 to give you a gap in the linkage. You...
  24. Thread: Gear Noise

    by grizzly03
    Replies
    1
    Views
    89

    Gear Noise

    Since the day I got my Erevo 2.0 it always had a gear whine. I thought it was normal, being an all new drive-line compared to the V1. I finally have had time and batteries to run this truck. My motor...
  25. Replies
    7
    Views
    173

    Run it first then decide on upgrades. It is a lot...

    Run it first then decide on upgrades. It is a lot of fun stock. It does take a beating and still drives away. Once you start upgrading, depending on what you want it can start adding up in price. So...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4