Search:

Type: Posts; User: Axsion-Jaxn

Search: Search took 0.02 seconds.

  1. Replies
    2
    Views
    130

    I've seen where some aluminum center diff cups...

    I've seen where some aluminum center diff cups are supposed to sit into a larger bearing. Who is the manufacturer of your diff cup?
  2. Replies
    17
    Views
    570

    I am also on the quest for cooler motor temps...

    I am also on the quest for cooler motor temps with my Sl4sh. I'm trying to keep my rig in good working conditions. There seems to be a lot of factors involved. What works for some, may not work for...
  3. Replies
    409
    Views
    69,696

    You know what? Tightening the grub screws and...

    You know what? Tightening the grub screws and some locktite did clean up a lot of that play. Thanks
  4. Replies
    409
    Views
    69,696

    I ordered two Traxxas diff cups. At install, the...

    I ordered two Traxxas diff cups. At install, the plastic end held the output tightly. After a day of use, maybe three packs, all the same wiggle is there. Are my mip x dutys too much for these diff...
  5. Replies
    409
    Views
    69,696

    I had also checked the wheel nut. It did not seem...

    I had also checked the wheel nut. It did not seem to be loose when I checked. I regularly check most fasteners before and during use. I know that's a possibility. Thanks for your input.

    Do you...
  6. Replies
    409
    Views
    69,696

    I purchased Slash 4x4 platinum edition. My output...

    I purchased Slash 4x4 platinum edition. My output for the rear drive shafts, there's a lot of slop coming from the plastic bell end of the cup. When I installed mip x duty drive shaft I noticed the...
  7. Replies
    12
    Views
    836

    I also own a set of these for my Rustler. They...

    I also own a set of these for my Rustler. They seem very tough. My only concern is the added wear to bearings. Is there any opinion on MIP X Duty adding extra stress to bearings?


    I'm looking to...
  8. Replies
    25
    Views
    1,558

    I'll keep my eye on this thread. I want ad see...

    I'll keep my eye on this thread. I want ad see how it goes.
  9. Replies
    19
    Views
    744

    I dropped down to a 11T pinion gear and added...

    I dropped down to a 11T pinion gear and added the traxxas fan for my esc. Seems to be better with not overheating the esc. So now my gearing is 11\54.
  10. Replies
    10
    Views
    1,518

    Thanks for the help. I'm new to this so I'm bound...

    Thanks for the help. I'm new to this so I'm bound to make mistakes. Any suggestions on lubricants? I've just used WD-40. I'll probably switch over to brushless soon. I'll do the research but it's...
  11. Replies
    10
    Views
    1,518

    Titan 550 12T motor

    I'm new to RC. I have a 2wd electric Rustler with the stock Titan 550 12T motor. I burnt out my original and traxxas was awesome and sent me a replacement. I could explain more, but maybe I'll get...
Results 1 to 11 of 11