Search:

Type: Posts; User: Jeff23spl

Search: Search took 0.01 seconds.

  1. the thing is the front and rear axle spin at the...

    the thing is the front and rear axle spin at the same rpm if you have different tire size, one set will slow down the other. In the sand it won't be a problem because there isn't that much resistance...
  2. Replies
    4
    Views
    624

    i installed all the new hubs, knuckle and...

    i installed all the new hubs, knuckle and bearings...(differencial bearings take a bit of time...) some new bearing was a bit slack in the hub, i used blue locktite. after all that, my wheels was...
  3. Replies
    13
    Views
    2,290

    a good alternative to a noisy air compressor is...

    a good alternative to a noisy air compressor is an old compressor from a refrigerator connected to a portable air tank.
    i sourced parts from a local fridge repair shop and got them for 20$...
  4. is there just screws to open the back of a vXL...

    is there just screws to open the back of a vXL motor ? i would like to find a brushed one that could be serviced that easily just for fun.

    i just opened a 550 yesterday but there was metal...
  5. i,m also fairly new to this but what i...

    i,m also fairly new to this but what i experienced so far with a brushed motor is that you need to match your motor-battery and gear ratio for the type of use you are planning of doing. I personally...
  6. Replies
    4
    Views
    624

    which parts usually wear first

    i got my pede used and i noticed a lot more play in axles and steering than another one i compared with.

    I ordered some new parts to help it but i was curious to see which one are you usually...
  7. I searched a bit on each stampede manual and it...

    I searched a bit on each stampede manual and it seem the clutch gear 54T comes standard on each 4x4 models but brushed models should have a 9teeth pinion instead of my 11 so i ordered a 9teeths to...
  8. new to RC with much questions and wondering what is the stock spec of a Stampede 4x4

    A buddy of my and me each got a used Stampede 4x4, mine is red and he got a blue one....

    I'm new to all this but i know a little on mechanic and electronic so last weekend we were comparing our...
  9. Replies
    28
    Views
    2,307

    i'm i right to say 15 teeth would be a lot more...

    i'm i right to say 15 teeth would be a lot more than before ?

    2s with 3500kv = 25 900rpm x 11/54T = 5276 RPM at the shaft
    2s with 3300kv = 24 420rpm x 11/54T = 4975 and with 15/54 it would be...
Results 1 to 9 of 9