Search:

Type: Posts; User: zball94

Page 1 of 19 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    18
    Views
    2,378

    Well, after multiple failed attempts to get a...

    Well, after multiple failed attempts to get a refund through a simple paypal request, the case was escalated to a claim. Just this morning I FINALLY got my refund. Took long enough...
  2. Replies
    18
    Views
    2,378

    They really lost my respect after ignoring my...

    They really lost my respect after ignoring my emails inquiring about my batteries. A simple message saying "Out of stock, unsure of next shipment" would go a long way.

    Anyway update to the...
  3. Replies
    18
    Views
    2,378

    The batteries were claimed to be in stock. Also...

    The batteries were claimed to be in stock. Also the vendor stopped replying to all my emails until the dispute was opened.

    Now he's saying that he did the refund, yet I see nothing in my activity...
  4. Replies
    18
    Views
    2,378

    Fraudulent Battery Vendor: Bego Racing

    I ordered 2 Lipo batteries from Bego Racing on March 11. I emailed them a little over a month later because I had not received any shipping notice. Their reply was:



    Over 4 weeks later, I...
  5. Replies
    18
    Views
    2,287

    Yes I did. It's at 6v. I have a Hitec on...

    Yes I did. It's at 6v.

    I have a Hitec on order. Hopefully that works better.
  6. A Lipo battery pack has 2 or 3 cells (2s or 3s) ...

    A Lipo battery pack has 2 or 3 cells (2s or 3s)

    E-Revo requires 2 battery packs to operate (2s+2s=4s, 3s+3s=6s)

    More cells means more power. 4s is plenty of power, 6s is nuts.


    Traxxas...
  7. Replies
    8
    Views
    556

    You may want to clean the unglued area with...

    You may want to clean the unglued area with acetone to remove old dried glue, then rinse the area thoroughly with water. Clean bond sites are strong bond sites.
  8. Replies
    4
    Views
    124

    How tight did you set the new slipper? Sounds...

    How tight did you set the new slipper? Sounds like the old one was loose and burned, and now the new one is also too loose and starting to burn.
  9. Replies
    18
    Views
    2,287

    The servo turns fine with the tires in the air,...

    The servo turns fine with the tires in the air, however doesn't have enough power to turn them when stationary or moving forward. It turns a fraction of what it should and continually makes that high...
  10. Replies
    18
    Views
    2,287

    Sooo... I bought a Castle 10 amp EBEC and wired...

    Sooo... I bought a Castle 10 amp EBEC and wired it in, and the servo still struggles to turn and re-center itself, even while driving. It also makes that horrible servo screeching noise while...
  11. Replies
    18
    Views
    2,287

    It's the XErun 150A. I'll have to double check if...

    It's the XErun 150A. I'll have to double check if it can be raised.
  12. Replies
    18
    Views
    2,287

    The servo is not glitchy, just weak (that's a...

    The servo is not glitchy, just weak (that's a brown out right?) My built in BEC is 5.75v/3A. There's no binding in steering when felt by hand with the servo disconnected. And the truck will continue...
  13. Replies
    18
    Views
    2,287

    Savox Servo Struggles to Turn Wheels

    I have a Savox 1231sg in my Maxx, which is good for 444oz. It struggles to re-center after turning, so I figured the weak BEC is to blame. My question is, for those running power hungry Savox servos,...
  14. Replies
    10
    Views
    791

    This must be it. I unplugged the servo and the...

    This must be it. I unplugged the servo and the ESC & rx lights are green. If I plug in the servo while the system is on, they go all flickery. Then unplug and they're back to normal.

    Now the real...
  15. Replies
    10
    Views
    791

    In the manual it says the ESC will flash green...

    In the manual it says the ESC will flash green steady if throttle trim is off. The flickering is nowhere near the same pattern as the flashing.
  16. Replies
    10
    Views
    791

    They're fully charged. The TX worked with my...

    They're fully charged. The TX worked with my Rustler 10 minutes before.
  17. Replies
    10
    Views
    791

    Green Light Flickers on ESC

    When I go to power up my ESC, the light flickers. It's not flashing like it's in programming mode, it looks more like a flickering neon sign. It also does not respond to transmitter input and the...
  18. Replies
    7
    Views
    462

    It's not supposed to be all the way tight,...

    It's not supposed to be all the way tight, there's usually some threads showing. What you gotta do is turn it till the wheel is at the desired angle of camber. It's usually 0 or -1
  19. Replies
    2
    Views
    736

    Internet Woes on Acer Laptop

    My mother's laptop is terribly slow. It takes forever to load a page and frequently times out. Only internet based tasks are slow, off line actions like transferring files are normal speed. No other...
  20. Replies
    6
    Views
    362

    Large heavy tires can cause heat as well.

    Large heavy tires can cause heat as well.
  21. Replies
    14
    Views
    1,565

    You don't need beadlocks to tape tires. Just buy...

    You don't need beadlocks to tape tires. Just buy the rubber and rims separate, wrap the inside with gorilla tape, and glue them up.
  22. Replies
    5
    Views
    980

    Not sure on the pinion, but honestly there's no...

    Not sure on the pinion, but honestly there's no point to installing that motor. Steering/handling will be terrible and 90% of the power will be unusable.
  23. Replies
    7
    Views
    1,899

    http://img.tapatalk.com/d/13/05/21/du7enuju.jpg ...

    http://img.tapatalk.com/d/13/05/21/du7enuju.jpg

    Not exactly the same shade (the wing was done with the same dye) but still looks good!
  24. Replies
    6
    Views
    998

    I think the heat you lose from lower gearing will...

    I think the heat you lose from lower gearing will show up in added heat from the higher voltage. Unfortunately there's no easy way to go from high speed runs to heavy offroading without heat...
  25. Replies
    12
    Views
    672

    Titan 775 or dewalt to stay brushed, or go...

    Titan 775 or dewalt to stay brushed, or go brushless.
Results 1 to 25 of 473
Page 1 of 19 1 2 3 4