Search:

Just tossed a lipo and micro mamba combo into my new latrax rally . I have the 12mm hex upgrade for it but I can't seem to figure out which tire wheel combo upgrade... does anyone have some info for...

Cool I'll try soldering together

I'm running both motor & esc fan, external Castle Bec and obviously a servo as well. Just got me some lights but there's no room for them in my reciever my question is can I splice wires on fans and...

Revolvers all the way

cpstack suspension setup, tire & wheel combo is what will keep your truck in control no matter how big motor/esc combo is... my T bone wheelie bar also really helps keep control under power unless of...

Proline pro trac kit may work the arms are extended

I'm running mm2 / 2200kv on 3s geared 20/50 things a beast I'm ready to step up try 4s i think...

What gearing u running with that

Same thing happened to me few months ago the servo went bad it would cut power to everything for a few seconds everytime I turned the wheel . New servo solved my problem

I'm running rpm but i think i wanna switch to alum... u guys think the strc are worth getn over the traxxas? seems there double the price

I ran the protrac kit on my p4de for a while along with mip x dutys. U shouldn't have a problem as long as u ordered the protrac kit for a pede 4x4 it will fit don't worry. Just a word of caution the...

How's that beast run on 4s?

Sorry to go off a bit but while u guys are talkn batteries Does spc 4s lipo fit in a stampede? I'm currently running traxxas 3s on my 1/8th scale pede but I think I'm ready to bump up to 4s and spc...

swapped out old servo with new one today. problem was the servo esc is running normal now. I have a castle bec i also picked up I think it set to default of 5.1v do i need to change that output to...

Ordered new servo and castle bec i think the servo is shot

I have been running the same setup for a year without problem which is mm2/2650kv on 3s... however last week i switched to a new 2200kv motor and everything seemed fine i ran the truck twice with no...

I'm pretty sure my traxxas servo is shorting out. When I turn wheel on my futaba controller my mm2 cuts off all power for a few seconds then powers up again . When I disconnect my servo from receiver...

I found couple days ago after inspection I had a bad rear diff which I think was contributing to high temps on my 2650kv motor... Today I installed and brand new xo rear diff and installed my new...

I just picked up a 2200kv motor this week. i plan on getn into a revo soon and I figured id grab a 2200 now to see how it runs in my pede. switching from my 2650 to the 2200 can I expect lower temps?...

I am running mm2/2650kv on 3s I just recently cleaned and rebuilt my factory diffs and put 50k front and 30k rear and I gotta say since I've done it I have noticed on pavement if there's a little...

I ordered castle motor fan for my 2650 been using it for about a week. Gotta say the fan seems to have zero effect on lowering temps at all. I saw on eBay a few bigger more expensive heat sink fans...

a little horror story for u guys why I decided to upgrade to the Futaba. My first truck that got me back into RC world (since 1980's when i was young) was a stampede 2wd ... i bought it used...

i settled on futaba 3pl with 4ch receiver $114 on ebay... gotta say what a huge upgrade from the traxxas setup the range I'm getting now is great. Ive yet to drive the truck far to even get it out of...

I don't really know much about transmitter, recievers, servos the futaba 3pl Is there a specific receiver I should match it up with?

Thanks I'll give those a look