Search:

Type: Posts; User: grizzly03

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    73
    Views
    1,046

    Have you thought about the servo saver? In a...

    Have you thought about the servo saver? In a different thread you said this issue started after you replaced the stock servo when it went bad, then you had trouble installing the included spring....
  2. Replies
    1
    Views
    27

    Check to see if the clutch shoe spring is broken,...

    Check to see if the clutch shoe spring is broken, bad clutch bearings, or the idle is too high. Slipper clutch would have no effect. If the engine clutch bell doesn't turn the truck wouldn't move.
  3. Replies
    7
    Views
    174

    I use this site to help figure out where to start...

    I use this site to help figure out where to start with gearing: https://scriptasylum.com/rc_speed/index.html.

    I dropped one tooth on the pinion gear on the stock tire/motor setup. I don't have a...
  4. What are your batteries? Are they good? If these...

    What are your batteries? Are they good? If these batteries are used in another vehicle and that vehicle acts the same way, I would say something is wrong with the batteries.
  5. Check to make sure all three motor wire...

    Check to make sure all three motor wire connections are tight.
  6. Replies
    2
    Views
    71

    Compare his antenna to yours. If your running...

    Compare his antenna to yours. If your running the 2.4Ghz radio the antenna part past the metal end needs to be correct.
  7. Replies
    7
    Views
    123

    Once the engine is tuned, major carb adjustments...

    Once the engine is tuned, major carb adjustments are not needed. Each time I take mine out I usually only need to adjust the high speed needle a small amount and rarely touch the low speed needle.
  8. Replies
    7
    Views
    174

    I want those tires! They are on my wishlist. ...

    I want those tires! They are on my wishlist. Have you changed the gearing?
  9. Traxxas TSM is in the receiver. Doesn't matter...

    Traxxas TSM is in the receiver. Doesn't matter what the ESC.
  10. Thread: Covid-19

    by grizzly03
    Replies
    29
    Views
    955

    I live in upstate NY and it is different. Some...

    I live in upstate NY and it is different. Some things are surreal. I don't get out much for health reasons. Today I went out to a Dr. appt. and the normal traffic was gone, hardly any vehicles. ...
  11. Replies
    4
    Views
    190

    Circled is the screw that is in the newer style...

    Circled is the screw that is in the newer style cases. These screws that they added has made the stock setup much more reliable. I shimmed my new diffs, but that is my personal preference. Shimming...
  12. I found a picture I have of the 3.3 servo saver...

    I found a picture I have of the 3.3 servo saver to give you an idea of how it looks. (If you decide to switch)

    https://live.staticflickr.com/65535/49553982723_dc4ac2b613_o.jpgSMaxxservosaver
  13. I decided on some parts: Tekin RX4 ESC &...

    I decided on some parts:
    Tekin RX4 ESC & ROC412HD 2300kv motor
    Promodeler DS470BLHV Servo
    Robinson Racing 16t pinion
    Traxxas 8247X metal servo horn
    ...
  14. I switched over to the Rx NiMh packs. For me...

    I switched over to the Rx NiMh packs. For me it's a more convenient setup. No need to open up the battery box to replace the AA batteries. The battery pack setup has an extra lead so you can...
  15. Replies
    12
    Views
    415

    Have you tried to center the steering servo with...

    Have you tried to center the steering servo with the servo horn off? Truck turned on to allow servo to go to its center and steering trim at neutral before re-installing of servo horn.
  16. It has been a while as I forgot how I installed....

    It has been a while as I forgot how I installed. But I do remember having some trouble installing the new spring. I kind of remember something about compressing it before installing the screw. I...
  17. That's the setup I switched to. I think all you...

    That's the setup I switched to. I think all you need is (2)bearings and a servo horn in addition to that part.
  18. Replies
    6
    Views
    595

    You could install a waterproof ESC.

    You could install a waterproof ESC.
  19. Replies
    5
    Views
    613

    I like those tires too! I enjoy the sound they...

    I like those tires too! I enjoy the sound they make running across my yard. Sounds like animal hoofs galloping. :D
  20. When I installed the 2085x servo and spring I...

    When I installed the 2085x servo and spring I tightened it down. The way that I see how it works is you can only make the spring so tight and no tighter when the pieces mate. I don't see how it can...
  21. You could always upgrade to the t-maxx 3.3 servo...

    You could always upgrade to the t-maxx 3.3 servo saver setup. It's a much better design.
  22. Replies
    5
    Views
    245

    This should help page 12 of a Slash w/OBA manual:...

    This should help page 12 of a Slash w/OBA manual: https://traxxas.com/sites/default/files/58076-24-OM-EN-R02.pdf
  23. My stock X-maxx servo acted similar to this. ...

    My stock X-maxx servo acted similar to this. Stopped working, walked over to the truck, take off the body and unplug the batteries. Nothing loose, turned it back on and it worked again. Later on...
  24. Replies
    11
    Views
    583

    Sharp looking trucks!! I like the colored in...

    Sharp looking trucks!! I like the colored in letters, that really adds to the look.
  25. Replies
    55
    Views
    1,418

    Running on a hard surface like concrete or...

    Running on a hard surface like concrete or asphalt allows the vehicle to slide when you have an accident. Unfortunately running out in a grass field doesn't allow any parts to slide, it seems to...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4