Search:

Type: Posts; User: Crock

Page 1 of 20 1 2 3 4

Search: Search took 0.08 seconds.

  1. Thread: Lubing bearings?

    by Crock
    Replies
    28
    Views
    2,279

    I replaced all my summit bearing with ceramics...

    I replaced all my summit bearing with ceramics years ago for the same price or cheaper than standard bearings. I spent a few days searching Ebay until I found a bearing with a high bearing rating.....
  2. Replies
    25
    Views
    2,747

    U cant set gear mesh like that. It will have to...

    U cant set gear mesh like that. It will have to be set again when u go bl

    Sent from my SM-G950W using Tapatalk
  3. Replies
    10
    Views
    989

    I think over the last few years the quality of...

    I think over the last few years the quality of traxxas electronics has severely dropped. The original motor in my summit lasted through years of abuse. The next 3 replacements barely lasted 1 run...
  4. Replies
    4
    Views
    343

    I'm pretty sure it reads the voltage from motor...

    I'm pretty sure it reads the voltage from motor side battery voltage only. As lipo cut off kicks in when motor side reaches cut off not a combined voltage

    Sent from my SM-G950W using Tapatalk
  5. Replies
    3
    Views
    450

    Do u know for sure battery's are good? Servo is a...

    Do u know for sure battery's are good? Servo is a good possibility as well. Unplug it and run the veh off the ground and see what happens. The servo in my crawler went bad and made the throttle...
  6. Pretty much anything u put in their is going to...

    Pretty much anything u put in their is going to loosen up after a few runs as alum is so soft.. I would use set pin and another strait across to balance back out

    Sent from my SM-G950W using...
  7. Replies
    12
    Views
    961

    What is your current radio not doing for you?

    What is your current radio not doing for you?
  8. Replies
    18
    Views
    2,312

    swap out the controller. first thing when i had...

    swap out the controller. first thing when i had my nitro's as the old 27's are just to unreliable when going that fast.
  9. Replies
    29
    Views
    1,681

    More than likely the reason traxxas went duel...

    More than likely the reason traxxas went duel servos is they did not want to spend the money on R&D to create a stronger servo when in the end they can just charge the customer more and add another...
  10. Thread: Summit cooling

    by Crock
    Replies
    2
    Views
    464

    Never had a issue with cooling. As long as its...

    Never had a issue with cooling. As long as its geared properly for the motor in it should have no issue

    Sent from my SM-G950W using Tapatalk
  11. Replies
    18
    Views
    2,312

    With the above find a good you tube video. Tuning...

    With the above find a good you tube video. Tuning is done by both ear and hand...

    Sent from my SM-G950W using Tapatalk
  12. Replies
    2
    Views
    285

    Iv always stuck with the plastic ends that way if...

    Iv always stuck with the plastic ends that way if it takes a good hit they will come apart or break. Better than something else braking and only takes a min to change out. Sometimes im able just to...
  13. Replies
    8
    Views
    3,147

    Before u start playing with lipo batteries you...

    Before u start playing with lipo batteries you need to read everything u can find until u understand and are comfortable charging and storing

    Sent from my SM-G950W using Tapatalk
  14. Replies
    18
    Views
    2,312

    Never buy a nitro car without seeing it run and...

    Never buy a nitro car without seeing it run and drive unless u have good experiance fixing them... with that being said I suggest u hit YouTube and start watching vids on running and tuning. While...
  15. Replies
    15
    Views
    657

    Whoops think one thing and type another... but I...

    Whoops think one thing and type another... but I did used to use a heat gun to start sometimes if I was having issues getting started or it was cold out and I still wanted to play

    Sent from my...
  16. Thread: Wobbly steering

    by Crock
    Replies
    8
    Views
    538

    Bearings cant remember what I ordered but they...

    Bearings cant remember what I ordered but they were cheap and on Ebay. This was a few years ago and still good

    Sent from my SM-G950W using Tapatalk
  17. Replies
    15
    Views
    657

    Definately need a heat gun for tuning..

    Definately need a heat gun for tuning..
  18. Thread: Rebuild prolems

    by Crock
    Replies
    13
    Views
    377

    To me that sounds like improperly meshed gears or...

    To me that sounds like improperly meshed gears or something let go on slipper

    Sent from my SM-G950W using Tapatalk
  19. Thread: Rebuild prolems

    by Crock
    Replies
    13
    Views
    377

    How is your slipper adjusted? Have not watched...

    How is your slipper adjusted? Have not watched the video but when they are slipping they can get loud. My summet just screams under full throttle and coasting at speed

    Sent from my SM-G950W using...
  20. Thread: Rebuild prolems

    by Crock
    Replies
    13
    Views
    377

    Lol... I did the same thing when I put a new...

    Lol... I did the same thing when I put a new servo in my summit... took a bit of head scratching before I caught what I did

    Sent from my SM-G950W using Tapatalk
  21. Replies
    1
    Views
    65

    U can still drift with a properly adjusted...

    U can still drift with a properly adjusted slipper. I do it with my trucks all the time but when they bind up into something the slipper kicks in

    Sent from my SM-G950W using Tapatalk
  22. That's been in use for years already. Started...

    That's been in use for years already. Started with plane,/heli trainers and progressed from their

    Sent from my SM-G950W using Tapatalk
  23. Thread: Rebuild prolems

    by Crock
    Replies
    13
    Views
    377

    Wow.. that's the hard way to do it... just pop...

    Wow.. that's the hard way to do it... just pop off the horn and put it on a true 90 degree angle to the servo so you can see a common point across the servo when u go both ways... make sure your trim...
  24. Thread: Wobbly steering

    by Crock
    Replies
    8
    Views
    538

    Don't have a xmaxx but knuckles look similar in...

    Don't have a xmaxx but knuckles look similar in style to my summit. I had tire wobble a replaced the bearing. It was better but not gone. I ordered new ceramics with a higer abec rating. Fully cured...
  25. Thread: Multiple cars

    by Crock
    Replies
    13
    Views
    1,176

    I run mine on both my summit and my crawler......

    I run mine on both my summit and my crawler... once and a while i have to rebind to one or the other. i dont have any phone app or such.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4