Search:

Type: Posts; User: Gungho

Search: Search took 0.02 seconds.

  1. Replies
    6
    Views
    143

    The way it fits now with my soft case lipo is...

    The way it fits now with my soft case lipo is still snug like you are experiencing. The only problem I had was one of my balancing wires on my lipo broke off, probally because of the tight fit. Now...
  2. Replies
    6
    Views
    143

    I cut out the plastic "wall" in the battery tray,...

    I cut out the plastic "wall" in the battery tray, below where the esc is mounted, in my rustler to make more room to fit a venom 5400ma 3s battery. You can always stuff a styrofoam block or something...
  3. Replies
    22
    Views
    364

    I dont know if it has been mentioned but you...

    I dont know if it has been mentioned but you should also replace the wheel bushings that are stock in the xl5 rustler with bearings. Makes for a much smoother ride and its a cheap upgrade. You dont...
  4. Replies
    2
    Views
    145

    Help with rustler 2wd tranny issues.

    My spur is spinning with throttle on but car wont move. If I lift the back end up the wheels will start spinning a little, one more than the other. I had to replace the pin on the spur shaft that...
  5. Seriously just try using one piece of two sided...

    Seriously just try using one piece of two sided tape on the esc, another on the spot where want to mount it and stick them together. I got some heavier tape at the hobby shop and cook the stickey...
  6. I had the exact same problem with my esc when I...

    I had the exact same problem with my esc when I converted my xl5 brushed to brushless. Take a sharp edge and scratch both surfaces and clean and dry to remove dust, oils etc. Take some 2 sided tape...
  7. Replies
    10
    Views
    1,486

    I bashed on only grass and did a lot of jumps for...

    I bashed on only grass and did a lot of jumps for a couple months with the 12t titan before going brushless. I never had any issues with my motor and I didn't even break it in right, just started...
  8. Replies
    8
    Views
    446

    Problem solved. The remote was not connected to...

    Problem solved. The remote was not connected to my reciever. My man Cole at traxxas support told me how to pair them up. I just got in from my first run around the yard:) Love it.
  9. Replies
    8
    Views
    446

    My new xl5 rustler wont run

    When I tried to charge the nimh cell the charger went from red (charging) to green (charge complete) in less than an hour. After connecting the battery to my rustler and pressing the esc button, the...
Results 1 to 9 of 9