Search:

Type: Posts; User: starluck rc

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    276

    It did help. I ran a 7XL on stock driveshafts...

    It did help. I ran a 7XL on stock driveshafts with the dowel mod. Most guys running steel driveshafts were eating diffs and transmissions.
  2. The 540 motors have 25mm spacing. The 380 motors...

    The 540 motors have 25mm spacing. The 380 motors have 16mm spacing.
  3. I’ve got a dusty roller with E-Max transmission...

    I’ve got a dusty roller with E-Max transmission sitting around plus most of a new 3.3 I never did anything with myself.
  4. Replies
    8
    Views
    3,029

    Glad I read this thread. Just tore apart my new...

    Glad I read this thread. Just tore apart my new Summit to shim the rear diff, but I see no play whatsoever. Hoping for the same on the front although it sucks to have done all the work when not...
  5. Replies
    3
    Views
    2,004

    Nice.... I have a lot of 20mm brushless motors to...

    Nice.... I have a lot of 20mm brushless motors to choose from both 30mm and 40mm length. Haven't picked up any of the 1/18 vehicles yet to try them out.
  6. Thread: Motors

    by starluck rc
    Replies
    4
    Views
    1,024

    Or possibly a Graupner Speed 400.

    Or possibly a Graupner Speed 400.
  7. That's generally how the magnets fail. I didn't...

    That's generally how the magnets fail. I didn't have any 380 sized rotors in my parts box. I do have quiet a few 5000kv motors though. I'll probably stick with the big block. Got to get the diffs...
  8. Same idea I came up with. It’s a shame the...

    Same idea I came up with. It’s a shame the Sidewinders got slightly bigger. The old version fits perfectly between those tabs.
  9. Finally found the info.... 16mm spacing.

    Finally found the info.... 16mm spacing.
  10. Since I have the big block motor plate, does...

    Since I have the big block motor plate, does anyone know the mounting hole spacing for the VXL motor plate?
  11. Not looking to get kicked out on my first day...

    Not looking to get kicked out on my first day back. I have a 1/16 Summit on the way, so more to come.
  12. 8S doesn’t have to be any different than 4S.........

    8S doesn’t have to be any different than 4S...... twice the voltage/half the current.... same power output. Now if you are talking about 8S on a motor designed for 4S.....good luck!
  13. Replies
    6
    Views
    1,456

    I would keep it under 4000rpm/v for a 3S setup.

    I would keep it under 4000rpm/v for a 3S setup.
  14. I was speaking of a non-Velineon branded motor. ...

    I was speaking of a non-Velineon branded motor. I have dozens. LOL!
  15. Although you should be able to get an entire new...

    Although you should be able to get an entire new motor for under $50.
  16. Replies
    7
    Views
    783

    Would you be the same person I already messaged...

    Would you be the same person I already messaged at rctech?
  17. My "new" roller is listed right here for $250.

    My "new" roller is listed right here for $250.
Results 1 to 17 of 39
Page 1 of 2 1 2