Search:

Type: Posts; User: marmarmarmit

Page 1 of 2 1 2

Search: Search took 0.02 seconds.

  1. Replies
    9
    Views
    3,061

    I can't edit my post but, I found the part...

    I can't edit my post but, I found the part numbers that fit, #7461x front shocks, #7462x rear shocks, #7444 front springs, and #7446 rear springs. I have plenty of hardware to replace the old shock...
  2. Replies
    9
    Views
    3,061

    I'll purchase some GTRs, what is the part # for...

    I'll purchase some GTRs, what is the part # for ones that will fit the rustler? What springs should I buy for bashing?
  3. Replies
    9
    Views
    3,061

    I guess i'll go with the GTR's. I found a set of...

    I guess i'll go with the GTR's. I found a set of 4 with oil for $45 on amazon. I need recommendation on springs for handling on rough terrain, right now the truck hits bumps too hard and struggles to...
  4. Replies
    9
    Views
    3,061

    I can't upgrade the ultra shocks, i have a bent...

    I can't upgrade the ultra shocks, i have a bent shaft that destroyed the rear shock, I used pliers to straiten it but it didn't. I guess the question is which set of shocks are better for responding...
  5. Replies
    9
    Views
    3,061

    Rustler Bashing Shock Setup/Upgrade

    'Tis the Season and I am looking for the best rustler shock upgrade for anywhere around $50. I know this has been talked about before in another thread, but that thread is eight years old. My ultra...
  6. Replies
    15
    Views
    1,375

    If you haven't already I would definitely...

    If you haven't already I would definitely recommend upgrading the bell crank. I am running 4 2.8'' badlands and my steering is perfect and more responsive than ever. I let my friend drive the rustler...
  7. The traxxas servo saver adapters will not fit on...

    The traxxas servo saver adapters will not fit on the hitec servo, I destroyed my servo and servo saver in a wreck with an 8th scale buggy, and decided to upgrade. Hitec's adapters that they provide...
  8. Replies
    4
    Views
    201

    Thanks so much for the help. I need wires because...

    Thanks so much for the help. I need wires because the esc otherwise would have to be ziptied to the body.
  9. Replies
    4
    Views
    201

    Motor Wire Extensions?

    I have a rustler VXL and I put the velineon system in another car and bought a cheap brushless motor just to mess around with. it had 4mm terminals so i threw in a sidewinder ESC and the wires are...
  10. Replies
    25
    Views
    1,515

    I think the rustler could really use a re-vamp or...

    I think the rustler could really use a re-vamp or just more value, I 100% doubt that they will stop selling it, there is way too much interest and a market for them. I would want traxxas to either...
  11. Replies
    14
    Views
    281

    5 amps is great for longer life of the lipo. I...

    5 amps is great for longer life of the lipo. I infer that this is for a rustler/bandit, if not you need not read this. I bought the exact same pack and thought it didn't fit but then discovered the...
  12. I geared down 5 teeth on my rustler VXL and had...

    I geared down 5 teeth on my rustler VXL and had an intedgy fan and a vilenon fan anyway so I installed them because I was not able to touch the motor for more tha 3 seconds 3/4 through a run. my ESC...
  13. I have figured it out, thanks for all the help, I...

    I have figured it out, thanks for all the help, I used a 3mm drill bit to make the hole bigger, and to shrink the saver I used a belt sander which allowed me to very accurately cut the saver into any...
  14. do you have a pic? if not by side holes do you...

    do you have a pic? if not by side holes do you mean the ones on he bottom left or right? or the bottom center? I can make them bigger for the 3mm screw i just need to know where.
    Sorry about the...
  15. Thanks for the reply, that does solve my problem...

    Thanks for the reply, that does solve my problem for the screw fitting, I just have to fit the tall saver into the very short compartment of the rustler, the pedes mount the saver under so it doesn't...
  16. Replies
    5
    Views
    120

    If its not too tight see if your bushing is...

    If its not too tight see if your bushing is stopped up by taking the wheel off and investigating the carrier itself. it might be able to be fixed with just a very very little amount of WD-40. there...
  17. Help! how to modify the kimbrough #124 to fit in the rustler

    I bought a hitec servo and my stock servo saver was slipping everywhere and was stripping out, even with thread locker. I read around a lot and the general understanding was to get a servo saver...
  18. I will definitely look into the prolines, maybe...

    I will definitely look into the prolines, maybe some traction compound for the track. Thanks for the reply, do you have any recommendations as far as keeping the system cool?
  19. Good Street/Clay Tires for Rustler VXL? + motor and esc temp help.

    I have a rustler VXL and already bough 4 badlands for bashing, but wanted something for the street that I could take to the track also. Its hard packed clay, and my street is a very rough and partly...
  20. I was driving my Ve8 and my buddy was driving my...

    I was driving my Ve8 and my buddy was driving my rustler and we made some sick jumps and had some gravel races, the rustler is on badlands, and the ve8 was just on some pins. I was driving like a...
  21. Replies
    27
    Views
    481

    I think the sound is just a matter of the motor's...

    I think the sound is just a matter of the motor's rpm with different gears. What are the temps for both gears after a run?
  22. Replies
    27
    Views
    481

    I am confused when you say choppier and purred, i...

    I am confused when you say choppier and purred, i believe I know what you are talking about, was it noise like whine that kinda sounded choppy and the other one just had a smooth one tone noise? I...
  23. Replies
    27
    Views
    481

    My rustler runs on 19t and the stock spur, but I...

    My rustler runs on 19t and the stock spur, but I have proline badlands on, I would not do anything over 21t with the stock spur, i belive 86t. If you want to run forever 3s isn't the way to go, it...
  24. Thanks a lot, if I can't use one of the hi-tech...

    Thanks a lot, if I can't use one of the hi-tech ones Ill use one of those.
  25. Thanks for the quick Reply, it came with several...

    Thanks for the quick Reply, it came with several replacement horns but all were too big, The traxxas servo came with two extra parts that go between the servo horn and the servo, they might have...
Results 1 to 25 of 26
Page 1 of 2 1 2