Search:

Type: Posts; User: Cody2462

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    5
    Views
    294

    Thanks for the suggestion! I'm looking at a savox...

    Thanks for the suggestion! I'm looking at a savox right now, as I havent been able to find the hitec servo yet...
  2. Replies
    5
    Views
    294

    Sorry, i meant that the servo never stops...

    Sorry, i meant that the servo never stops spinning to a side once the esc is turned on (and connected to remote), so it doesn't matter if the gears are stripped or not.
  3. Replies
    8
    Views
    820

    Venom 1600mah, 7.2v for around 20 min run time...

    Venom 1600mah, 7.2v for around 20 min run time full throttle, 45 slow. its nimh
  4. Replies
    5
    Views
    294

    2080 servo spins forever, doesnt stop

    Hello, recently got into a crash, which stripped some of my plastic gears. however, when i tested the servo, it spins forever. steering has no affect on the spin at all- it keeps spinning- ive only...
  5. Replies
    10
    Views
    576

    I can't hear the raspy sound anymore. the motor...

    I can't hear the raspy sound anymore. the motor runs just fine. is this a good thing?
  6. Replies
    3
    Views
    411

    I would think that because the ride height is...

    I would think that because the ride height is different, the rally might have a different suspension setup.
  7. Replies
    4
    Views
    500

    Since our soldering iron doesn't work we just...

    Since our soldering iron doesn't work we just taped the connectors together. yeah... bad idea. I dont push the truck or use it as much till I can actually solder it. is there a way to add extra wire...
  8. Replies
    8
    Views
    448

    Found this video ...

    Found this video

    https://www.youtube.com/watch?v=kzNkkgHL8Gg
  9. Replies
    4
    Views
    500

    _______________________________

    _______________________________
  10. Replies
    10
    Views
    576

    Thanks for the the suggestion. very...

    Thanks for the the suggestion. very budget-friendly, like I need. though my old soldering iron broke and I have no Idea how to replace the motor. is it just the connection of polarities on the motor?...
  11. do you mean with new ones too? I have no problems...

    do you mean with new ones too? I have no problems with mine so far but it is only 6 months old so...
  12. Replies
    4
    Views
    588

    I can tell you that you need the REVO a-arms, I...

    I can tell you that you need the REVO a-arms, I think REVO (tie rods?) and revo bodyposts and body if you want. and maybe some new suspension parts. i think they bolth are the same besides from those.
  13. happens after you restart too? (Unplug, plug in...

    happens after you restart too? (Unplug, plug in battery?)
  14. Replies
    10
    Views
    576

    Well.. that was the first time testing it in the...

    Well.. that was the first time testing it in the snow... it happened before i went in the snow. I always keep the slash inside too. are their any other reasons that this may happen? and... thanks for...
  15. Replies
    10
    Views
    576

    Thanks for the reply :) helped a lot. I dont...

    Thanks for the reply :) helped a lot. I dont think the diff is shredded because I tested the motor outside the car but I dont understand why the motor would die. I had waited a few weeks getting a...
  16. Replies
    10
    Views
    576

    Raspy Brushed motor

    So, just today, I got my motor, ESC, and receiver back into my 1/16 slash and did a throttle test just to make sure that the channels were right. however when I pressed on the throttle, I found out...
  17. Replies
    6
    Views
    2,441

    I think you already know this but if the negative...

    I think you already know this but if the negative and posotive touch you will short and, decresed battery life.
  18. Thread: Battery dead?

    by Cody2462
    Replies
    2
    Views
    1,396

    try a controller reset. I have 1/16 slash so I...

    try a controller reset. I have 1/16 slash so I wouldn't know for the teton. try looking at some fourms on how you can do that.

    if the steering works it's probally not dead. unless you can hear the...
  19. Replies
    11
    Views
    27,900

    Pretty sure NIMH starts to die off when you leave...

    Pretty sure NIMH starts to die off when you leave it uncharged or un-used for too long. you could try repeately charging to max and then running it all the way down until it works. otherwise it's...
  20. Replies
    10
    Views
    1,301

    I don't know, sorry, but I would recommend...

    I don't know, sorry, but I would recommend emailing them if you have a question.
  21. Replies
    2
    Views
    708

    Power is fine on the brushed models it's the...

    Power is fine on the brushed models it's the total weight of the car. I think.
  22. Replies
    20
    Views
    6,732

    I don't really know if this is related or not,...

    I don't really know if this is related or not, but my first Traxxas came with a Car charger/ cigarette lighter charger whatever. my first and only traxxas is 1/16 slash, so dont even know if it's...
  23. Replies
    4
    Views
    500

    Questionable Smoldering quality

    ok, this is a bit weird. I first went into my first Traxxas on march 16, 2018. I haven't been really driving this thing that hard. since the purchase, I rarely crashed the truck, and besides from a...
  24. Replies
    13
    Views
    599

    has problems with the stock battery being a bit...

    has problems with the stock battery being a bit too long, on my personal expierence with the mini slash. a venom pack solves the problem, they're also better. dont go for the traxxas nimh pack.
  25. Replies
    13
    Views
    599

    The 1/16 revo got problems with the battery....

    The 1/16 revo got problems with the battery. after frequent uses, the wire connecting to the battery starts to pinch, and will evuntally short circut. the reason is because the battery is slightly...
Results 1 to 25 of 40
Page 1 of 2 1 2