Results 1 to 5 of 5

Thread: Clean up

  1. #1
    RC Enthusiast
    Join Date
    Feb 2008
    Posts
    24

    Clean up

    just a thought, since the new emaxx is water resistant is it possible to wash it with a hose? not a power washer just garden hose and some cleaner. should make clean up a snap. any one try this?

  2. #2
    RC Enthusiast
    Join Date
    Feb 2008
    Location
    Saskatchewan Canada
    Posts
    49
    if I am not mistaken it says it is okay to use a hose right in the manual under cleanup
    Mark

  3. #3
    RC Competitor
    Join Date
    Jan 2002
    Location
    Kannapolis, nc
    Posts
    83
    I use low pressure from a hose with brush and spray cleaner. Then use air compressor to dry.

  4. #4
    RC poster
    Join Date
    Feb 2008
    Posts
    8
    Yup!



    TT

  5. #5
    RC Racer
    Join Date
    Jan 2008
    Posts
    126
    I've used a hose and a shower. Just make sure the pressure head is low. I don't have a compressor, so I angle the truck sideways and put a oscillating fan right in front of it on high (after a towel dry).

    I also use compressed air on the areas by the servors, ESC and receiver. I try to be conservative though as that can get expensive. I will probably end up buying a small compressor when I get an airbrush.
    Res Ipso Loquitor
    "Let the good times roll"

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •