How To?

[humayrayakongkinaon]

I got onther pair of trim tab and i want to know, how you guys did it without messing it up?
thanks, Peter.

[jpierce81]

you use a flashlight on the inside.

[orca44]

When you use the flashlight to locate the mounting location, you do not need to drill out the holes as there is a thin layer of plastic over the mounting holes, just use a sharp pointed object to pierce the layer of plastic since the mounting tab is already there. Start one screw and then the other.

Hope this brief description helps.....

[breeze400]

Hear read this! Lol
http://forums.offshoreelectrics.com/...cond-Trim-Tabs

I used this and it works! Use a all or something pointed. I used the point of a ice pick. Heat it on a stove. Mark the holes with a marker. Touch the mark on your hole with the heated point and it goes right through! Carfull your only going thru a thin piece! Don't go all the way through!

[humayrayakongkinaon]

hahahaha, i went ahead and just eyeball it with a hobby knife and got it all right on the spot.
thanks ya'll.