proud (new to me) owner of a MERV!!!

[50togo]

looks all good! zip around pretty good!

[humayrayakongkinaon]

well, cant run my merv at this moment, my servo gave up on me yesterday. i called LHS to see if they have one and how much it is, and they did have it for $27.99+tax so, i order one off ebay stock one for $17.98 shipped and it wont be here until friday. time to take out the big brother, i guess.

[50togo]

which servo did you get?

[humayrayakongkinaon]

LOL, i should have mention it, its the stock 2080 servo, maybe later i'll get something much better than the stock and use the stock one for spare, just incase my better one acting-up crazy.

which servo did you get?

[50togo]

Maybe you will get lucky and it will last a while

[humayrayakongkinaon]

Maybe you will get lucky and it will last a while

i sure hope so. i know on my ERBE my 2075 servo has been used thru 3 trucks (t-maxx,revo 3.3 and to now ERBE) and still going strong.

[50togo]

If only they built the 2080 that strong!

[humayrayakongkinaon]

i did another speed run today, gear it 32t/45t and temps stays at low 98 on ESC and motor at 115 but, my lipo is at 67, is that a bit hot for a lipo? i know my gens ace lipos on my ERBE are just warm to the touch but then again they are hardcase. anyway heres my vid? \/ \/ \/
http://www.youtube.com/watch?v=iZ7Nr...&feature=g-upl

[50togo]

sounds like it was below ambient temperature .that is fine!

[humayrayakongkinaon]

hi guys, got a little updates, since i'm in low budget right now (LOL), i dicided to make my own front sway bar out of my other rc parts. its turns out to be very well, i hope it works as its suppose to be, lol. here are some pics


this is what i did 2 weeks ago, installed a longer wheelbase. right is the longer wheelbase a-arm while the left is the stock a-arm, that 10mm really makes a difference i can open my batt door without hitting the tire, lol.

and this is the pinion i have on now on my speed run video 32t, not much room if you go any higher, this is pretty much the highest pinion you can put on.

[linux38]

Looks awesome!

[humayrayakongkinaon]

thanks linux38, i'm working on the rear sway bar, i'm tring to replicate my ERBE rear sway bar. hope i can pull this out.