Hi -
I've got a Traxxas 2S 10,000 MAH battery and the EZ Peak Plus. When charging the last two times all starts out fine and when I check on the battery later it is charging at less than 1amp (.8, .7) and eventually times out. The mah put into the battery is aroudn 3~4,000. Before this it would charge at a higher amperage and be finished in 1:30 minutes with a full charge (10,000MaH +).

I don't want to hurt the battery, it is only 2ish months old. Any ideas? If I wind up calling Traxxas, how do I read the each cell voltge (when it is charging, done charging, etc....)