Ok, so I am starting to get my parts in for slayer pro. I have my sway bars, rear wing mount, and push rods. I want to drill out my shocks to 1.2mm as suggested, and up my fluid to 45 wt. I was reading over some of the options I can mess around with, one being the rear A-arm pins. They come stock in the rear on the bottom. The manual says that by moving this you can lower you CG, but by using it lower its like a poor mans sway bar. With the set up I am planning on, for the shocks, and adding the slayer sway bar kit, should I raise the pins, or keep them where they are?