Results 1 to 3 of 3
  1. #1
    RC Enthusiast
    Join Date
    Feb 2012
    SW arkansas

    Slipper Clutch Problems

    I built my revo several months back and have had the bugs worked out for a while, i put a picco .26 on it and had no problems till now. for some reason the slipper clutch will not grab anymore. started when i went to slayer gears in the trans. i put a brand new slipper setup on it and it lasted almost a full tank of fuel and then it started slipping and won't grab at all. any suggestions?

  2. #2
    RC Competitor
    Join Date
    Oct 2012
    why u put slayer gears in it? does that basically lower ur gear ratio??
    revo 3.3 tmaxx 3.3 ofna hyper 7

  3. #3
    Marshal Double G's Avatar
    Join Date
    May 2008
    The pads may be glazed so you would need to clean them up. You could do the E-Revo slipper upgrade or use the T-Maxx classic brake pad (with the hexagon center) as a slipper clutch pad.
    The Super Derecho

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts