Correct Pins?

[Skink910]

http://www3.towerhobbies.com/cgi-bin...&I=LXEMC9&P=SM

Are these the pins I would need to run with GH bulkheads and RPM arms?

Also this what I need for the axles?
http://buy.traxxas.com/product_info....oducts_id=8459

Or do I need something more?

Refer to: http://traxxas.com/forums/showthread...and-I-broke-it...

[trax de max]

I would measure and check, click=

[Skink910]

I would measure and check, click=

Thank you! Those are the right pins

Do you know about those axles?

[trax de max]

Not too sure on the shafts. The pins I linked and the ones you linked are two different lengths. The measurement is taking from the groove, not the total length.

[Skink910]

Not too sure on the shafts. The pins I linked and the ones you linked are two different lengths. The measurement is taking from the groove, not the total length.

Strange, the part number is the same, but you are right on the lengths they are a little different. I'll have to look and make sure I'm getting the right lengths. I measured and found out which ones I need. Still need to know about those shafts tho lol

[M n M]

Stock E Maxx axle shafts for the 3903 or 3905 are these:
http://buy.traxxas.com/advanced_sear...rch=partsearch

Or the whole assembly are these:
http://buy.traxxas.com/advanced_sear...rch=partsearch

Or for a factory fix, these CVD's
http://buy.traxxas.com/product_info....oducts_id=8047

Plus

These extended drive cups work really good together
http://buy.traxxas.com/product_info....oducts_id=7441

[Skink910]

Stock E Maxx axle shafts for the 3903 or 3905 are these:
http://buy.traxxas.com/advanced_sear...rch=partsearch

Or the whole assembly are these:
http://buy.traxxas.com/advanced_sear...rch=partsearch

Or for a factory fix, these CVD's
http://buy.traxxas.com/product_info....oducts_id=8047

Plus

These extended drive cups work really good together
http://buy.traxxas.com/product_info....oducts_id=7441

Thank you very much! I think I need the whole assembly, and what are those extended drive cups use for?

[M n M]

and what are those extended drive cups use for?

Some guys have reported that the steel CVD has a tendency to work it's way out of the supplied drive cups when bashing hard. So by replacing the shorter cups with the extended one you keep the drive shaft in the cup.

[Skink910]

Ahh I see, thank you. You guys have been so much help!