Results 1 to 6 of 6
  1. #1
    RC Competitor
    Join Date
    Sep 2011
    Location
    North Jersey
    Posts
    90

    Steel Center drive shaft

    Where do you put the o rings they give you because in the directions it doesn't say anything about putting the o rings on so I left them off.
    Drive it like you stole it

  2. #2
    RC Racer
    Join Date
    Feb 2013
    Location
    Auckland, NZ
    Posts
    208
    Im assuming from my experience with the diff-hub cv shafts that the o-rings would cover the pins holding the drive cups.

    Cheers.

  3. #3
    RC Competitor
    Join Date
    Jun 2013
    Location
    Afghanistan
    Posts
    55
    The Center Drive Shafts come with two extra o rings in case the pre-installed ones break. Keep them in your toolbox because eventually one may break. In fact it may be better just to shrink wrap that area because if one of the o rings does break you will probably loose the pin inside.

  4. #4
    RC Qualifier
    Join Date
    Nov 2008
    Location
    St. Louis, MO
    Posts
    447
    Would shrink wrap last at that spot?
    RSR
    KPGC treasurer (& BuRPS addict)

  5. #5
    RC Competitor
    Join Date
    Sep 2011
    Location
    North Jersey
    Posts
    90
    Ok thanks because I thought I forgot something.
    Drive it like you stole it

  6. #6
    RC Enthusiast
    Join Date
    Aug 2013
    Posts
    31
    Your suppose too have the o rings on the end of the balls of the shaft it helps with the slop of the shaft. Well the o rings go in between the hub and the shaft.


    Edited to remove offensive content.
    Last edited by cooleocool; 08-06-2013 at 08:26 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •