Results 1 to 6 of 6
  1. #1
    RC Competitor
    Join Date
    Jun 2009
    Posts
    59

    OS 21 eating slipper clutch

    The clutch bell with this engine installed is going about 1-2mm past where it should on the spur gear and it is eating into the slipper clutch assembly. I do not know of any adjustments that can be made to compensate for this.

  2. #2
    RC Racer Rooky78's Avatar
    Join Date
    Feb 2016
    Location
    Naptown
    Posts
    231
    Oblong the holes in your chassis for the trans.

  3. #3
    RC Competitor
    Join Date
    Jun 2009
    Posts
    59
    Dude. Thats what I was afraid of.

  4. #4
    RC Racer Rooky78's Avatar
    Join Date
    Feb 2016
    Location
    Naptown
    Posts
    231
    Or you could try a Robinson Steel spur

  5. #5
    Marshal Double G's Avatar
    Join Date
    May 2008
    Posts
    13,498
    You shouldn't need to do any modification to the frame or anything else with the 21TM; I haven't nor has anyone else (both Revo and Slayer) reported needing to with the engine. Make sure the flywheel is properly positioned and the spur gear is facing the correct way.
    The Super Derecho

  6. #6
    RC Competitor
    Join Date
    Jun 2009
    Posts
    59
    Patched everything back up. Set the mesh and getting past interference just barely, I would say by maybe .5mm. This sound normal?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •