Results 1 to 2 of 2
  1. #1
    RC poster
    Join Date
    Jul 2016
    Posts
    1

    Pulling the slayer & slash outta the closet

    Slayer: Servos doing nothing at all when turned on.

    New batteries.

    Have 6.5V going to the 2216 receiver. Have voltage coming out of receiver on all channels.

    Have a known good transmitter, and new crystals installed

    Have tested fault with another 2216 receiver, and nothing.

    Any good ideas?? Vehicle worked fine when boxed up a while back.

    Slash: mamba setup, everything comes on and works as it should. Except that in either forward or reverse it just lunges and then stops. Do I just need to plug it into the laptop and tune it? Never have done that.

  2. #2
    Marshal Double G's Avatar
    Join Date
    May 2008
    Posts
    13,570
    If you have a good transmitter and receiver and the servos do not work then swap out known good servos and see if there is still a problem.
    The Super Derecho

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •