Results 1 to 4 of 4
  1. #1
    RC Qualifier
    Join Date
    Feb 2016
    Location
    San Diego, CA
    Posts
    264

    Do they make a screw and nut for the top screw of the steering block?

    *Title should be for the rear hub carrier, not the steering block.*

    So I have the Pro-Line hinge pin set, but now this screw came all the way out tonight and dropped. Fortunately my son found it in the backyard. I'm wondering if Pro-Line or someone makes a longer screw and nut for this spot similar to the hinge pin set? Thanks.

    Last edited by 55Chevy; 11-19-2016 at 10:27 PM.

  2. #2
    RC Champion traxxasfan21's Avatar
    Join Date
    Nov 2015
    Location
    in sunny CA
    Posts
    1,113
    I would use blue loctite on the screw if you have the alum ones and a longer screw.
    Too much power is just enough

  3. #3
    RC Racer Spanner Monkey's Avatar
    Join Date
    Sep 2010
    Posts
    234

    Do they make a screw and nut for the top screw of the steering block?

    You can use any m3 hex screw.

    Screw in from the front and add a nyloc nut.



    Makes general maintenance much easier
    Last edited by Spanner Monkey; 11-20-2016 at 06:58 AM.
    Seek forgiveness, not permission

    Caveat lector!

  4. #4
    RC Champion MikeMcE's Avatar
    Join Date
    Feb 2016
    Location
    Deep in the Everglades
    Posts
    1,291
    Metal on metal you need loctite.


    Hang up and Drive
    HANG UP AND DRIVE!
    Slash 2wd 4x4
    PRO MT Yeti 4x4

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •